BS EN 10210-1:2006

Foreword
1 Scope
2 Normative references
3 Terms, definitions and symbols
   3.1 Terms and definitions
   3.2 Symbols
4 Classification and designation
   4.1 Classification
   4.2 Designation
5 Information to be obtained by the manufacturer
   5.1 Mandatory information
   5.2 Options
   5.3 Example of an order
6 Requirements
   6.1 General
   6.2 Steel manufacturing process
   6.3 Structural hollow section manufacturing process
   6.4 Delivery condition
   6.5 Chemical composition
   6.6 Mechanical properties
   6.7 Technological properties
   6.8 Surface condition
   6.9 Non-destructive testing of welds
   6.10 Tolerances and mass
7 Inspection
   7.1 Types of inspection
   7.2 Types of inspection document
   7.3 Summary of inspection
8 Sampling
   8.1 Frequency of tests
   8.2 Preparation of samples and test pieces
9 Test methods
   9.1 Chemical analysis
   9.2 Mechanical tests
   9.3 Visual inspection and dimensional check
   9.4 Non-destructive testing
   9.5 Retests, sorting and reprocessing
10 Marking
11 Evaluation of conformity
Annex A (normative) Structural hollow sections of non-alloy
                        quality steels - Chemical composition
                        and mechanical properties
Annex B (normative) Structural hollow sections of fine grain
                        steels - Chemical composition and
                        mechanical properties
Annex C (normative) Location of samples and test pieces
Annex D (normative) Evaluation of conformity
Annex ZA (informative) Clauses of this European Standard
                        addressing the provisions of the
                        EU Construction Products Directive
Bibliography

This revision permits the publication of BS EN 10210-1 to be adopted as a Harmonised Standard under the Constuction Products Directive (CPD) 89/106/EC - Structural metallic products. Work on the Standard has been undertaken with the guidance of the CEN Consultant. The revision has introduced changes to the scope by adding an additional steel grade for S420 square and rectangular sections, the normative reference and aligns the production processes and the technical requirements between two parallel products (BS EN 10210-1 and BS EN 10219-1).