I.S. EN 10210-1:2006

Foreword
1 Scope
2 Normative references
3 Terms, definitions and symbols
   3.1 Terms and definitions
   3.2 Symbols
4 Classification and designation
   4.1 Classification
   4.2 Designation
5 Information to be obtained by the manufacturer
   5.1 Mandatory information
   5.2 Options
   5.3 Example of an order
6 Requirements
   6.1 General
   6.2 Steel manufacturing process
   6.3 Structural hollow section manufacturing process
   6.4 Delivery condition
   6.5 Chemical composition
   6.6 Mechanical properties
   6.7 Technological properties
   6.8 Surface condition
   6.9 Non-destructive testing of welds
   6.10 Tolerances and mass
7 Inspection
   7.1 Types of inspection
   7.2 Types of inspection document
   7.3 Summary of inspection
8 Sampling
   8.1 Frequency of tests
   8.2 Preparation of samples and test pieces
9 Test methods
   9.1 Chemical analysis
   9.2 Mechanical tests
   9.3 Visual inspection and dimensional check
   9.4 Non-destructive testing
   9.5 Retests, sorting and reprocessing
10 Marking
11 Evaluation of conformity
Annex A (normative) Structural hollow sections of non-alloy
                        quality steels - Chemical composition
                        and mechanical properties
Annex B (normative) Structural hollow sections of fine grain
                        steels - Chemical composition and
                        mechanical properties
Annex C (normative) Location of samples and test pieces
Annex D (normative) Evaluation of conformity
Annex ZA (informative) Clauses of this European Standard
                        addressing the provisions of the
                        EU Construction Products Directive
Bibliography

Defines technical delivery conditions for hot finished hollow sections of circular, square, rectangular or elliptical forms and applies to hollow sections formed hot, with or without subsequent heat treatment, or formed cold with subsequent heat treatment to obtain equivalent metallurgical conditions to those obtained in the hot formed product.