EN 10258 : 1997

Foreword
1 Scope
2 Normative references
3 Definitions
4 Designation
5 Condition of delivery
6 Tolerances on thickness
7 Tolerances on width
8 Preferred coil inner diameters
9 Tolerances on length
10 Flatness and edge waviness tolerances
11 Tolerances on out-of-squareness
12 Tolerances on edge camber
13 Ordered format (for cut lengths)
14 Measurement
Annex
A (informative) Bibliography

Applicable to cold-rolled stainless, heat- and creep-resisting steel flat products with thickness not in excess of 3.0 mm, and rolled widths under 600 mm, in the form of narrow strip (coils with a rolled width <600 mm), slit cold-rolled narrow strip and cut lengths derived from slit cold-rolled narrow strip or cold-rolled strip. Not applicable to cold-rolled stainless, heat resisting and creep resisting steel wide strip and plate/sheet or to cold rolled products having a specified standard.