EN ISO 9445:2006

Foreword
1 Scope
2 Normative reference
3 Terms and definitions
4 Information to be supplied by the purchaser
5 Type of delivery and delivery condition
6 Preferred thicknesses
7 Tolerances on thickness
8 Tolerances on width
9 Preferred coil inner diameters for cold-rolled products
10 Tolerances on length
11 Tolerances on edge camber
12 Tolerances on squareness
13 Tolerances on flatness
14 Edge waviness tolerances for cold-rolled strip
15 Form of coils
16 Ordered format for plate/sheet and cut lengths
17 Measurement of thickness
18 Measurement of width
19 Measurement of length
20 Measurement of edge camber
21 Measurement of squareness
22 Measurement of flatness and waviness

Describes the tolerances on dimensions and form for continuously cold-rolled stainless steel narrow strip, in thicknesses of up to and including 3 mm and in rolling widths of less than 600 mm. It also applies to cut lengths taken from such strip.