EN 50109-2-4:1995
Withdrawn
Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 2-4: Particular requirements for centre contacts of RF connectors, series SMZ
06-22-1995
12-15-1995
Foreword
Introduction
1 Scope
2 Normative references
3 Definitions
4 Requirements
5 Tests and acceptance requirements
6 Calibration procedure
7 Marking, labelling and packaging
8 Type Approval Authority
Annexes
A Crimping tool outline dimensions and constructional
details (normative)
B User control gauges (normative)
C Test piece, locator jig and run-out measurement
details (normaitve)
Part 2-4 of this European Standard specifies detail requirements, limiting dimensions and operating forces for hand crimping tools incorporating a system of multiple indentors of the 8-indent type, commonly known as `Octodent'. It includes test requirements for the tool crimping action, under load, using a test-piece
| Committee |
CLC/TC 46X
|
| DocumentType |
Standard
|
| PublisherName |
European Committee for Standards - Electrical
|
| Status |
Withdrawn
|
| Standards | Relationship |
| PN EN 50109-2-4 : 2002 | Identical |
| BS EN 50109-2-4:1996 | Identical |
| DIN EN 50109-2-4:1995-11 | Identical |
| NEN EN 50109-2-4 : 1995 | Identical |
| NBN EN 50109 2-4 : 2000 | Identical |
| NF EN 50109-2-4 : 2004 | Identical |
| I.S. EN 50109-2-4:1997 | Identical |
| CEI EN 50109-2-4 : 1997 | Identical |
| UNE-EN 50109-2-4:1993 | Identical |
| CECC 22000 : 1993 | GENERIC SPECIFICATION: RADIO FREQUENCY COAXIAL CONNECTORS |
| EURONORM 88 : LATEST | REPLACED |
| EURONORM 83 : 1970 | HEAT-TREATABLE STEELS; QUALITY SPECIFICATIONS |
| EURONORM 86 : 1970 | STEELS FOR FLAME-HARDENING AND INDUCTION-HARDENING - QUALITY SPECIFICATIONS |
| EURONORM 31 : 1969 | SEMI-FINISHED PRODUCTS FOR FREE HAMMER FORGING; DEVIATION TOLERANCES FOR DIMENSION, FORM AND WEIGHT |
| EURONORM 61 : 1982 | HOT-ROLLED HEXAGON STEEL |
| ISO 468:1982 | Surface roughness — Parameters, their values and general rules for specifying requirements |
| EN 50109-1:1995 | Hand crimping tools - Tools for the crimp termination of electric cables and wires for low frequency and radio frequency applications - Part 1: General requirements and tests |
| ISO 286-1:2010 | Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 1: Basis of tolerances, deviations and fits |
| ISO 286-2:2010 | Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts |
| EURONORM 84 : 1970 | CASE HARDENING STEELS; QUALITY SPECIFICATIONS |
| EURONORM 95 : 1979 | HEAT-RESISTANT STEELS; TECHNICAL TERMS OF DELIVERY |
| ISO 4287-1:1984 | Surface roughness — Terminology — Part 1: Surface and its parameters |
| EURONORM 85 : 1970 | NITRIDING STEELS; QUALITY SPECIFICATIONS |