EN 62475:2010
Current
High-current test techniques - Definitions and requirements for test currents and measuring systems
12-03-2010
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Procedures for qualification and use of a measuring
system
5 Tests and test requirements for an approved measuring
system
6 Steady-state direct current
7 Steady-state alternating current
8 Short-time direct current
9 Short-time alternating current
10 Impulse currents
11 Current measurement in high-voltage dielectric testing
12 Reference measuring systems
Annex A (informative) - Uncertainty of measurement
Annex B (informative) - Examples of the uncertainty calculation
in high-current measurements
Annex C (informative) - Step-response measurements
Annex D (informative) - Convolution method for estimation of
dynamic behaviour from step-response measurements
Annex E (informative) - Constraints for certain wave shapes
Annex F (informative) - Temperature rise of measuring
resistors
Annex G (informative) - Determination of r.m.s. values of
short-time a.c. current
Annex H (informative) - Examples of IEC standards with high
current tests
Bibliography
Annex ZA (normative) - Normative references to international
publications with their corresponding European
publications
IEC 62475:2010 is applicable to high-current testing and measurements on both high-voltage and low-voltage equipment. It deals with steady-state and short-time direct current (as e.g. encountered in high-power d.c. testing), steady-state and short-time alternating current (as e.g. encountered in high-power a.c. testing), and impulse-current. In general, currents above 100 A are considered in this International Standard, although currents less than this can occur in tests. This standard also covers fault detection during, for example, lightning impulse testing.
| Committee |
CLC/SR 42
|
| DocumentType |
Standard
|
| PublisherName |
European Committee for Standards - Electrical
|
| Status |
Current
|
| Standards | Relationship |
| CEI EN 62475 : 2011 | Identical |
| PN EN 62475 : 2010 | Identical |
| VDE 0432-20:2011-09 | Identical |
| NBN EN 62475 : 2011 | Identical |
| NEN EN IEC 62475 : 2010 | Identical |
| NF EN 62475 : 2011 | Identical |
| IEC 62475:2010 | Identical |
| I.S. EN 62475:2010 | Identical |
| BS EN 62475:2010 | Identical |
| DIN EN 62475:2011-09 | Identical |
| UNE-EN 62475:2012 | Identical |