I.S. EN 62475:2010
Current
HIGH-CURRENT TEST TECHNIQUES - DEFINITIONS AND REQUIREMENTS FOR TEST CURRENTS AND MEASURING SYSTEMS
Hardcopy , PDF
English
01-01-2010
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 Procedures for qualification and use of a measuring system
5 Tests and test requirements for an approved measuring system
6 Steady-state direct current
7 Steady-state alternating current
8 Short-time direct current
9 Short-time alternating current
10 Impulse currents
11 Current measurement in high-voltage dielectric testing
12 Reference measuring systems
Annex A (informative) - Uncertainty of measurement
Annex B (informative) - Examples of the uncertainty calculation
in high-current measurements
Annex C (informative) - Step-response measurements
Annex D (informative) - Convolution method for estimation of
dynamic behaviour from step-response measurements
Annex E (informative) - Constraints for certain wave shapes
Annex F (informative) - Temperature rise of measuring resistors
Annex G (informative) - Determination of r.m.s. values of
short-time a.c. current
Annex H (informative) - Examples of IEC standards with high
current tests
Bibliography
Annex ZA (normative) - Normative references to international
publications with their corresponding European
publications
Pertains to high-current testing and measurements on both high-voltage and low-voltage equipment.
| DevelopmentNote |
For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
|
| DocumentType |
Standard
|
| Pages |
108
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Standards | Relationship |
| IEC 62475:2010 | Identical |
| EN 62475:2010 | Identical |
| BS EN 62475:2010 | Equivalent |