EN ISO 1461:2009

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
  4.1 General
  4.2 Hot dip galvanizing bath
  4.3 Information to be supplied by the purchaser
  4.4 Safety
5 Acceptance inspection and sampling
6 Coating properties
  6.1 Appearance
  6.2 Thickness
  6.3 Renovation
  6.4 Adhesion
  6.5 Acceptance criteria
7 Certificate of compliance
Annex A (normative) - Information to be supplied
Annex B (normative) - Safety and process requirements
Annex C (informative) - Renovation of uncoated or damaged
        areas
Annex D (informative) - Determination of thickness
Annex E (informative) - Corrosion resistance of hot dip
        galvanized coatings
Bibliography

ISO 1461:2009 specifies the general properties of coatings and test methods for coatings applied by dipping fabricated iron and steel articles (including certain castings) in a zinc melt (containing not more than 2 % of other metals). It does not apply to the following:sheet, wire and woven or welded mesh products that are continuously hot dip galvanized;tube and pipe that are hot dip galvanized in automatic plants;hot dip galvanized products (e.g. fasteners) for which specific standards exist and which might include additional requirements or requirements which are different from those of ISO 1461:2009.After-treatment/over-coating of hot dip galvanized articles is not covered by ISO 1461:2009.