PREN 9138 : 200P1

Introduction
1 Scope
2 References
3 Terms and definitions
4 General requirements
5 Required information to be documented
6 Requirements for accepting product by individual lots
7 Requirements for accepting product under switching rules
8 Requirements for accepting product produced under process
  controls
9 Additional requirements for accepting products based on
  continuous sampling, skip-lot sampling, or methods
  for special cases
Annex A (informative) - Guidelines for assigning Initial
        Reliability Requirement quality levels
Annex B (informative) - Acronym log
Annex C (informative) - Mathematics for accepting product
        under lot-by-lot inspection
Annex D (informative) - Guidelines and recommendations
        for successful implementation of statistical
        product acceptance methods
Annex E (informative) - Discussion on the technical rationale
        and history of the relationship of quality parameters
        to reliability
Annex F (informative) - Guidelines for choosing a statistical
        product acceptance technique and quality parameter
Annex G (informative) - Guidelines and recommendations
        for accepting product by individual lots
Annex H (informative) - Guidelines for some special
        acceptance methods
Annex I (informative) - Guidelines and recommendations
        for accepting product produced under switching
        rules
Annex J (informative) - Guidelines and recommendations
        for accepting product produced under process
        controls
Annex K (informative) - Guidelines and recommendations
        for accepting product based on continuous
        sampling

Sets up requirements when implementing statistical product acceptance methods to meet defined risk requirements.