02/103309 DC : DRAFT MAY 2002
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS EN 14455 - DEVICES TO PREVENT POLLUTION BY BLACKFLOW OF POTABLE WATER - PRESSURISED AIR INLET VALVES DN 15 TO DN 50 INCLUSIVE - FAMILY L, TYPE A AND TYPE B
Published date
23-11-2012
Publisher
Superseded date
31-10-2006
Superseded by
Sorry this product is not available in your region.
BS EN 14455
| Committee |
B/504/4
|
| DocumentType |
Draft
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO 3822-1:1999 | Acoustics — Laboratory tests on noise emission from appliances and equipment used in water supply installations — Part 1: Method of measurement |
| ISO 3822-4:1997 | Acoustics — Laboratory tests on noise emission from appliances and equipment used in water supply installations — Part 4: Mounting and operating conditions for special appliances |
| EN 1717:2000 | Protection against pollution of potable water in water installations and general requirements of devices to prevent pollution by backflow |
| ISO 5167:1980 | Measurement of fluid flow by means of orifice plates, nozzles and Venturi tubes inserted in circular cross-section conduits running full |
| ISO 7-1:1994 | Pipe threads where pressure-tight joints are made on the threads — Part 1: Dimensions, tolerances and designation |
| ISO 6509:1981 | Corrosion of metals and alloys — Determination of dezincification resistance of brass |
| EN 13959:2004 | Anti-pollution check valves - DN 6 to DN 250 inclusive family E, type A, B, C and D |
| ISO 9227:2017 | Corrosion tests in artificial atmospheres — Salt spray tests |
| ISO 965-1:2013 | ISO general purpose metric screw threads — Tolerances — Part 1: Principles and basic data |
| EN ISO 6509:1995 | Corrosion of metals and alloys - Determination of dezincification resistance of brass (ISO 6509:1981) |
| ISO 228-1:2000 | Pipe threads where pressure-tight joints are not made on the threads — Part 1: Dimensions, tolerances and designation |
Summarise
Sorry this product is not available in your region.