09/30192596 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
BS 4500 - LIMITS AND FITS - GUIDANCE FOR SYSTEM OF CONE (TAPER) FITS AND TOLERANCES FOR CONES FROM C = 1:3 TO 1:500, LENGTHS FROM 6 MM TO 630 MM AND DIAMETERS UP TO 500 MM
Hardcopy , PDF
English
30-09-2009
Foreword
Section 1: General
1 Scope
2 Normative references
3 Terms and definitions
Section 2: System of cone fits
4 Formation of cone fits
5 Calculation of axial displacements for
the hole basis system of cone fits
Section 3: System of cone tolerances
6 Cone diameter tolerance T[D]
7 Cone angle tolerance AT
8 Cone form tolerances T[F]
9 Cone section diameter tolerance T[DS]
10 Table of cone angle tolerances - structure
of the table
Annexes
Annex A (informative) - Effect on the cone fit of departures
of the internal and external cones from the basic cone
Annex B (informative) - Maximum cone angle deviations
resulting from the cone diameter tolerances (T[D]) for
100 mm cone length
Bibliography
| Committee |
TDW/4/-/1
|
| DocumentType |
Draft
|
| Pages |
53
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| BS EN 20286-1:1993 | ISO system of limits and fits ISO system of limits and fits. Bases of tolerances, deviations and fits |
| BS EN ISO 1119:2011 | Geometrical product specifications (GPS). Series of conical tapers and taper angles |
| BS ISO 3040 : 2009 | GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) - DIMENSIONING AND TOLERANCING - CONES |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.