09/30192613 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
BS 1916-3 - LIMITS AND FITS FOR ENGINEERING - PART 3: RECOMMENDATIONS FOR TOLERANCES, LIMITS AND FITS FOR LARGE DIAMETERS (GUIDANCE)
Hardcopy , PDF
English
30-09-2009
Foreword
Section 1: Introductory
1 Scope
2 Normative references
3 Terms and definitions
4 A review of the problems
5 The practical effect of errors on tolerances
and fits
Section 2: Limits and tolerances for large diameters
(19.69 in to 125 in)
6 Tolerance formula
7 Diameter steps
8 Fundamental inch tolerances
9 Fundamental deviations
10 Suggested associations of holes and shafts
Annexes
Annex A (informative) - Matched fits
Annex B (informative) - Graphical representation of
tolerance zones for holes and shafts
Bibliography
| Committee |
TDW/4/-/1
|
| DocumentType |
Draft
|
| Pages |
33
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| BS 2045:1965 | Preferred numbers |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.