09/30193399 DC : DRAFT MAY 2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 23529 - RUBBER - GENERAL PROCEDURES FOR PREPARING AND CONDITIONING TEST PIECES FOR PHYSICAL TEST METHODS
23-11-2012
30-11-2010
Foreword
1 Scope
2 Identification and record keeping
3 Standard laboratory conditions
3.1 Standard laboratory temperature
3.2 Standard laboratory humidity
3.3 Other conditions
4 Storage of sample and test pieces
5 Preparation of test pieces
5.1 Test piece thickness
5.2 Thickness adjustment
5.3 Test piece cutters
5.4 Maintenance of cutters
5.5 Preparation of test pieces by moulding
6 Conditioning
6.1 General
6.2 Conditioning times for subnormal or elevated temperatures
7 Measurement of the dimensions of test pieces
7.1 Method A - For dimensions less than 30 mm
7.2 Method B - For dimensions of 30 mm and up to and
including 100 mm
7.3 Method C - For dimensions over 100 mm
7.4 Method D - Non-contact method
8 Conditions of test
8.1 Duration of test
8.2 Temperature and humidity
9 Test chambers
9.1 General requirements for temperature-controlled chambers
9.2 Chambers operating at elevated temperatures
9.3 Chambers operating at subnormal temperatures
10 Test report
Annex A (normative) - Conditioning times for rubber test pieces
Bibliography
BS ISO 23529
| Committee |
PRI/22
|
| DocumentType |
Draft
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO 525:2013 | Bonded abrasive products — General requirements |
| ISO 3302-1:2014 | Rubber — Tolerances for products — Part 1: Dimensional tolerances |
| ISO 2393:2014 | Rubber test mixes — Preparation, mixing and vulcanization — Equipment and procedures |