14/30250433 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS EN ISO 8503-5 - PREPARATION OF STEEL SUBSTRATES BEFORE APPLICATION OF PAINTS AND RELATED PRODUCTS - SURFACE ROUGHNESS CHARACTERISTICS OF BLAST-CLEANED STEEL SUBSTRATES - PART 5: REPLICA TAPE METHOD FOR THE DETERMINATION OF THE SURFACE PROFILE
Hardcopy , PDF
English
31-03-2017
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
6 Maintenance and assurance of calibration
for the replica tape method
7 Procedure
8 Specification of acceptable error
9 Test report
Annex A (informative) - Measurement errors
associated with replica tape determination
of profile height
Annex B (informative) - Guidance on the correspondence
between replica tape and ISO comparator
determinations of profile height
Annex C (informative) - Grades of Replica Tape
Annex D (informative) - Service Life and Storage
Recommendations for Replica Tape
BS EN ISO 8503-5.
| Committee |
STI/21
|
| DocumentType |
Draft
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO 8503-3:2012 | Preparation of steel substrates before application of paints and related products — Surface roughness characteristics of blast-cleaned steel substrates — Part 3: Method for the calibration of ISO surface profile comparators and for the determination of surface profile — Focusing microscope procedure |
| ISO 8503-1:2012 | Preparation of steel substrates before application of paints and related products — Surface roughness characteristics of blast-cleaned steel substrates — Part 1: Specifications and definitions for ISO surface profile comparators for the assessment of abrasive blast-cleaned surfaces |
| ISO 8504-2:2000 | Preparation of steel substrates before application of paints and related products — Surface preparation methods — Part 2: Abrasive blast-cleaning |
| ISO 8503-4:2012 | Preparation of steel substrates before application of paints and related products — Surface roughness characteristics of blast-cleaned steel substrates — Part 4: Method for the calibration of ISO surface profile comparators and for the determination of surface profile — Stylus instrument procedure |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.