14/30257552 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 3245 - ROLLING BEARINGS - NEEDLE ROLLER BEARINGS, DRAWN CUP WITHOUT INNER RING - GEOMETRICAL PRODUCT SPECIFICATIONS (GPS), BOUNDARY DIMENSIONS AND TOLERANCES
Hardcopy , PDF
English
31-01-2016
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Boundary dimensions
6 Tolerances
7 Measurement of the smallest bore diameter
of needle roller complement
Annex A (informative) - Tolerances for shaft
raceway and housing bore
Bibliography
BS ISO 3245.
| Committee |
MCE/7
|
| DocumentType |
Draft
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO 2639:2002 | Steels — Determination and verification of the depth of carburized and hardened cases |
| ISO/TR 14638:1995 | Geometrical product specification (GPS) — Masterplan |
| ISO 8015:2011 | Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules |
| ISO 1132-2:2001 | Rolling bearings — Tolerances — Part 2: Measuring and gauging principles and methods |
| ISO 1101:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out |
| ISO 5593:1997 | Rolling bearings — Vocabulary |
| ISO 14253-1:2017 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications |
| ISO 1132-1:2000 | Rolling bearings — Tolerances — Part 1: Terms and definitions |
| ISO 286-1:2010 | Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 1: Basis of tolerances, deviations and fits |
| ISO 15241:2012 | Rolling bearings — Symbols for physical quantities |
| ISO 286-2:2010 | Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts |
| ISO 14405-1:2016 | Geometrical product specifications (GPS) — Dimensional tolerancing — Part 1: Linear sizes |
| ISO 14253-2:2011 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 2: Guidance for the estimation of uncertainty in GPS measurement, in calibration of measuring equipment and in product verification |
| ISO 10579:2010 | Geometrical product specifications (GPS) — Dimensioning and tolerancing — Non-rigid parts |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.