14/30262683 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 8062-4 - GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) - DIMENSIONAL AND GEOMETRICAL TOLERANCES FOR MOULDED PARTS - PART 4: GENERAL TOLERANCES FOR CASTINGS USING PROFILE TOLERANCING IN A GENERAL DATUM SYSTEM
Hardcopy , PDF
English
31-08-2017
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Rules
5 General tolerances
6 Required machining allowances
7 Draft angles (taper)
8 General drawing indication
Annex A (informative) - Concept of the general
tolerancing
Annex B (informative) - Selection of general
tolerances
Annex C (informative) - Selection of required
machining allowances RMA
Annex D (informative) - Example of using general
tolerances
Annex E (informative) - Calculation of the nominal
dimension of the moulded condition
Annex F (informative) - Relation to the
GPS-Matrix-Model
Bibliography
BS ISO 8062-4
| Committee |
TDW/4
|
| DocumentType |
Draft
|
| Pages |
32
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO/TR 14638:1995 | Geometrical product specification (GPS) — Masterplan |
| ISO 8015:2011 | Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules |
| ISO 5459:2011 | Geometrical product specifications (GPS) — Geometrical tolerancing — Datums and datum systems |
| ISO 2692:2014 | Geometrical product specifications (GPS) — Geometrical tolerancing — Maximum material requirement (MMR), least material requirement (LMR) and reciprocity requirement (RPR) |
| ISO 1101:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out |
| ISO/TS 8062-2:2013 | Geometrical product specifications (GPS) — Dimensional and geometrical tolerances for moulded parts — Part 2: Rules |
| ISO 10135:2007 | Geometrical product specifications (GPS) — Drawing indications for moulded parts in technical product documentation (TPD) |
| ISO 8062-1:2007 | Geometrical product specifications (GPS) — Dimensional and geometrical tolerances for moulded parts — Part 1: Vocabulary |
| ISO 1660:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Profile tolerancing |
| ISO 10579:2010 | Geometrical product specifications (GPS) — Dimensioning and tolerancing — Non-rigid parts |
| ISO 5458:1998 | Geometrical Product Specifications (GPS) — Geometrical tolerancing — Positional tolerancing |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.