15/30302776 DC : DRAFT JULY 2015
Superseded
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 15031-3 - ROAD VEHICLES - COMMUNICATION BETWEEN VEHICLE AND EXTERNAL EQUIPMENT FOR EMISSIONS-RELATED DIAGNOSTICS - PART 3: DIAGNOSTIC CONNECTOR AND RELATED ELECTRICAL CIRCUITS: SPECIFICATION AND USE
Published date
20-07-2015
Publisher
Superseded date
30-04-2016
Superseded by
Sorry this product is not available in your region.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviated terms
4 Conventions
5 Connector requirements
6 Ethernet
7 ACL for on-board pyrotechnic devices
Annex A (informative) - Ethernet pin assignment
option #1 and #2 according to ISO 13400-4
Annex B (informative) - Additional communication
line (ACL) according to ISO 26021 pin assignment
Bibliography
BS ISO 15031-3.
| Committee |
AUE/16
|
| DocumentType |
Draft
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO 15765-4:2016 | Road vehicles — Diagnostic communication over Controller Area Network (DoCAN) — Part 4: Requirements for emissions-related systems |
| IEEE 802.3-2012 | IEEE Standard for Ethernet |
| ISO 15031-1:2010 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 1: General information and use case definition |
| ISO 15031-4:2014 | Road vehicles — Communication between vehicle and external equipment for emissions-related diagnostics — Part 4: External test equipment |
| ISO 26021-4:2009 | Road vehicles — End-of-life activation of on-board pyrotechnic devices — Part 4: Additional communication line with bidirectional communication |
| ISO 6722-4:1993 | Road vehicles — Unscreened low-tension cables — Part 4: Conductor sizes and dimensions for thin-wall insulated cables |
| SAE J1962_201607 | Diagnostic Connector |
| ISO 14230-4:2000 | Road vehicles — Diagnostic systems — Keyword Protocol 2000 — Part 4: Requirements for emission-related systems |
| ISO 6722-3:1993 | Road vehicles — Unscreened low-tension cables — Part 3: Conductor sizes and dimensions for thick-wall insulated cables |
| ISO 13400-3:2016 | Road vehicles — Diagnostic communication over Internet Protocol (DoIP) — Part 3: Wired vehicle interface based on IEEE 802.3 |
| ISO 26021-5:2009 | Road vehicles — End-of-life activation of on-board pyrotechnic devices — Part 5: Additional communication line with pulse width modulated signal |
| SAE J1850_201510 | Class B Data Communications Network Interface |
Summarise
Sorry this product is not available in your region.