15/30325361 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS EN 1069-1 - WATER SLIDES - PART 1: SAFETY REQUIREMENTS AND TEST METHODS
Hardcopy , PDF
English
30-09-2017
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Materials and construction
6 Design
7 Safety requirements for water slides
8 Additional safety requirements for Types 1 to 10
9 Check and test runs
10 Designation and marking
Annex A (normative) - Splashdown areas
Annex B (normative) - Use of stainless steels
for water slides
Annex C (normative) - Design loads, accesses
and platforms
Annex D (normative) - Acceleration and
speed measurements
Bibliography
BS EN 1069-1.
| Committee |
SW/136
|
| DocumentType |
Draft
|
| Pages |
56
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| PREN 1069-1 : DRAFT 2015 | Identical |
| HD 60364-7-702:2010 | Low-voltage electrical installations - Part 7-702: Requirements for special installations or locations - Swimming pools and fountains |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| EN 13814:2004 | Fairground and amusement park machinery and structures - Safety |
| ISO 9606-1:2012 | Qualification testing of welders — Fusion welding — Part 1: Steels |
| EN ISO 13857:2008 | Safety of machinery - Safety distances to prevent hazard zones being reached by upper and lower limbs (ISO 13857:2008) |
| EN 10088-2:2014 | Stainless steels - Part 2: Technical delivery conditions for sheet/plate and strip of corrosion resisting steels for general purposes |
| EN 1176-1:2017 | Playground equipment and surfacing - Part 1: General safety requirements and test methods |
| EN 13451-1:2011+A1:2016 | Swimming pool equipment - Part 1: General safety requirements and test methods |
| EN 22768-1:1993 | General tolerances - Part 1: Tolerances for linear and angular dimensions without individual tolerance indications (ISO 2768-1:1989) |
| EN 10204:2004 | Metallic products - Types of inspection documents |
| ISO 13857:2008 | Safety of machinery — Safety distances to prevent hazard zones being reached by upper and lower limbs |
| EN ISO 9606-1:2017 | Qualification testing of welders - Fusion welding - Part 1: Steels (ISO 9606-1:2012 including Cor 1:2012 and Cor 2:2013) |
| EN 15288-2:2008 | Swimming pools - Part 2: Safety requirements for operation |
| EN 10088-1:2014 | Stainless steels - Part 1: List of stainless steels |
| EN 13451-2:2015 | Swimming pool equipment - Part 2: Additional specific safety requirements and test methods for ladders, stepladders and handle bends |
| EN 13451-3:2011+A3:2016 | Swimming pool equipment - Part 3: Additional specific safety requirements and test methods for inlets and outlets and water/air based water leisure features |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.