15/30328410 DC : DRAFT JULY 2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS EN 62052-11/AMD1 - ELECTRICITY METERING EQUIPMENT (AC) - GENERAL REQUIREMENTS, TESTS AND TEST CONDITIONS - PART 11: METERING EQUIPMENT
27-07-2015
31-07-2017
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Standard electrical values
5 Mechanical requirements and tests
6 Climatic conditions
7 Electrical requirements
8 Type test
Annex A (normative) - Relationship between ambient
air temperature and relative humidity
Annex B (normative) - Voltage wave-form for the tests
of the effect of voltage dips and short interruptions
Annex C (normative) - Test circuit diagram for the test of
immunity to earth fault
Annex D (normative) - Optical test output
Annex E (informative) - Test set-up for EMC tests
Annex F (informative/) Test schedule - Recommended test
sequences
Bibliography
BS EN 62052-11/Amd1.
| Committee |
PEL/13
|
| DocumentType |
Draft
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| IEC 60695-2-11:2014 | Fire hazard testing - Part 2-11: Glowing/hot-wire based test methods - Glow-wire flammability test method for end-products (GWEPT) |
| ISO 75-2:2013 | Plastics — Determination of temperature of deflection under load — Part 2: Plastics and ebonite |
| IEC 60085:2007 | Electrical insulation - Thermal evaluation and designation |
| IEC 62052-31:2015 | Electricity metering equipment (AC) - General requirements, tests and test conditions - Part 31: Product safety requirements and tests |
| IEC 60529:1989+AMD1:1999+AMD2:2013 CSV | Degrees of protection provided by enclosures (IP Code) |
| IEC 60068-2-75:2014 | Environmental testing - Part 2-75: Tests - Test Eh: Hammer tests |
| IEC 62058-11:2008 | Electricity metering equipment (AC) - Acceptance inspection - Part 11: General acceptance inspection methods |