16/30310691 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS EN ISO 294-1 - PLASTICS - INJECTION MOULDING OF TEST SPECIMENS OF THERMOPLASTIC MATERIALS - PART 1: GENERAL PRINCIPLES, AND MOULDING OF MULTIPURPOSE AND BAR TEST SPECIMENS
Hardcopy , PDF
English
31-08-2017
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Apparatus
5 Procedure
6 Report on test-specimen preparation
Annex A (informative) - Examples of runner configurations
Annex B (informative) - Standardized injection-moulding
mould components
Annex C (informative) - Example of an injection mould
Annex D (informative) - Methods for setting the injection
moulding parameters
Annex E (informative) - Methods of determining the hold
pressure and hold time
BS EN ISO 294-1.
| Committee |
PRI/82
|
| DocumentType |
Draft
|
| Pages |
34
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO 10350-2:2011 | Plastics — Acquisition and presentation of comparable single-point data — Part 2: Long-fibre-reinforced plastics |
| ISO 11403-3:2014 | Plastics — Acquisition and presentation of comparable multipoint data — Part 3: Environmental influences on properties |
| ISO 294-3:2002 | Plastics — Injection moulding of test specimens of thermoplastic materials — Part 3: Small plates |
| ISO 10350-1:2017 | Plastics — Acquisition and presentation of comparable single-point data — Part 1: Moulding materials |
| ISO 11403-2:2012 | Plastics — Acquisition and presentation of comparable multipoint data — Part 2: Thermal and processing properties |
| ISO 294-4:2001 | Plastics — Injection moulding of test specimens of thermoplastic materials — Part 4: Determination of moulding shrinkage |
| ISO 294-2:1996 | Plastics — Injection moulding of test specimens of thermoplastic materials — Part 2: Small tensile bars |
| ISO 179-1:2010 | Plastics — Determination of Charpy impact properties — Part 1: Non-instrumented impact test |
| ISO 11403-1:2014 | Plastics — Acquisition and presentation of comparable multipoint data — Part 1: Mechanical properties |
| ISO 20753:2008 | Plastics — Test specimens |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.