16/30341970 DC : 0
NA
Status of Standard is Unknown
BS ISO 1206 - ROLLING BEARINGS - NEEDLE ROLLER BEARINGS WITH MACHINED RINGS - BOUNDARY DIMENSIONS, GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) AND TOLERANCE VALUES
Hardcopy , PDF
English
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Nominal boundary and chamfer dimensions
6 Tolerances
7 Radial internal clearance
Annex A (informative) - Tolerances for shaft
raceways for needle roller bearings without
inner ring
Annex B (informative) - Symbols and terms as
given in ISO 1206:2001 in relation to
descriptions given in this International Standard
Bibliography
BS ISO 1206.
| Committee |
MCE/7
|
| DocumentType |
Draft
|
| Pages |
24
|
| PublisherName |
British Standards Institution
|
| Status |
NA
|
| ISO 2639:2002 | Steels — Determination and verification of the depth of carburized and hardened cases |
| ISO 8015:2011 | Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules |
| ISO 14638:2015 | Geometrical product specifications (GPS) — Matrix model |
| ISO 5459:2011 | Geometrical product specifications (GPS) — Geometrical tolerancing — Datums and datum systems |
| ISO/TS 17863:2013 | Geometrical product specification (GPS) — Tolerancing of moveable assemblies |
| ISO 1101:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out |
| ISO 5593:1997 | Rolling bearings — Vocabulary |
| ISO 14253-1:2017 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications |
| ISO 582:1995 | Rolling bearings — Chamfer dimensions — Maximum values |
| ISO 1132-1:2000 | Rolling bearings — Tolerances — Part 1: Terms and definitions |
| ISO 5753-1:2009 | Rolling bearings — Internal clearance — Part 1: Radial internal clearance for radial bearings |
| ISO 286-1:2010 | Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 1: Basis of tolerances, deviations and fits |
| ISO 15241:2012 | Rolling bearings — Symbols for physical quantities |
| ISO 286-2:2010 | Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes — Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts |
| ISO 14405-1:2016 | Geometrical product specifications (GPS) — Dimensional tolerancing — Part 1: Linear sizes |
| ISO 14253-2:2011 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 2: Guidance for the estimation of uncertainty in GPS measurement, in calibration of measuring equipment and in product verification |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.