17/30356713 DC
Current
The latest, up-to-date edition.
BS EN 88-3. Safety and control devices for gas burners and gas burning appliances. Part 3. Pressure and/or flow rate regulators for inlet pressures up to and including 500 kPa, electronic types
08-09-2017
European foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Test conditions and uncertainty of measurements
6 Design and construction
7 Performance
8 Electrical requirements
9 Electromagnetic compatibility (EMC)
10 Marking, installation and operating instructions
Annex A (informative) - Abbreviations and symbols
Annex B (informative) - Leak-tightness test for gas
controls - volumetric method
Annex C (informative) - Leak-tightness test for gas
controls - pressure loss method
Annex D (normative) - Conversion of pressure loss
into leakage rate
Annex E (normative) - Electrical/electronic component
fault modes
Annex F (normative) - Additional requirements for safety
accessories and pressure accessories as defined in
EC Directive 2014/68/EC
Annex G (normative) - Materials for pressurized parts
Annex H (normative) - Additional materials for pressurized
parts
Annex I (normative) - Requirements for controls used in
DC supplied burners and appliances burning gaseous
or liquid fuels
Annex J (normative) - Method for the determination of a
Safety integrity level (SIL)
Annex K (normative) - Method for the determination of a
Performance level (PL)
Annex L (informative) - Relationship between Safety integrity
level (SIL) and Performance level (PL)
Annex M (normative) - Reset functions
Annex N (informative) - Guidance document on environmental
Aspects
Annex O (normative) - Seals of elastomer, cork and synthetic
fibre mixtures
Annex ZA (informative) - Relationship between this European
Standard and the essential requirements of Directive
2009/142/EC aimed to be covered
Annex ZB (informative) - Relationship between this European
Standard and the essential requirements of Regulation
(EU) 2016/426 aimed to be covered
Annex ZC (informative) - Relationship between this European
Standard and the essential requirements of Directive
2014/68/EU aimed to be covered
Bibliography
BS EN 88-3.
| Committee |
GSE/22
|
| DocumentType |
Draft
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Standards | Relationship |
| PREN 88-3 : DRAFT 2017 | Identical |
| EN 10226-2:2005 | Pipe threads where pressure tight joints are made on the threads - Part 2: Taper external threads and taper internal threads - Dimensions, tolerances and designation |
| EN 175301-803:2006 | Detail Specification: Rectangular connectors - Flat contacts, 0,8 mm thickness, locking screw not detachable |
| EN 161:2011+A3:2013 | Automatic shut-off valves for gas burners and gas appliances |
| EN 1854:2010 | Pressure sensing devices for gas burners and gas burning appliances |
| IEC 60529:1989+AMD1:1999+AMD2:2013 CSV | Degrees of protection provided by enclosures (IP Code) |
| IEC 60730-1:2013+AMD1:2015 CSV | Automatic electrical controls - Part 1: General requirements |