AGMA 915-2 : A
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
INSPECTION PRACTICES - PART 2: CYLINDRICAL GEARS - RADIAL MEASUREMENTS
01-01-2005
02-03-2022
Foreword
1 Scope
2 Normative references
3 Symbols, corresponding terms and definitions
4 Measurement of radial composite deviations
5 Tooth thickness measurement with radial composite measurement
6 Verification of master gears and fixtures
7 Runout and eccentricity
Bibliography
Describes a code of practice dealing with inspection relevant to radial composite deviations and runout of cylindrical involute gears; i.e., with measurements referred to double flank contact.
| DevelopmentNote |
Supersedes AGMA ISO 10064-2. (04/2009) Supersedes AGMA 2000. (12/2009)
|
| DocumentType |
Standard
|
| PublisherName |
American Gear Manufacturers Association
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| AGMA 905 : A2017 | INSPECTION OF MOLDED PLASTIC GEARS |
| AGMA 935 : A | RECOMMENDATIONS RELATIVE TO THE EVALUATION OF RADIAL COMPOSITE GEAR DOUBLE FLANK TESTERS |
| AGMA 915-1 : A | INSPECTION PRACTICES - PART 1: CYLINDRICAL GEARS - TANGENTIAL MEASUREMENTS |
| AGMA 2015-1 : A | ACCURACY CLASSIFICATION SYSTEM - TANGENTIAL MEASUREMENTS FOR CYLINDRICAL GEARS |
| AGMA 935 : A | RECOMMENDATIONS RELATIVE TO THE EVALUATION OF RADIAL COMPOSITE GEAR DOUBLE FLANK TESTERS |
| ISO 701:1998 | International gear notation — Symbols for geometrical data |
| AGMA 2000 : A | GEAR CLASSIFICATION AND INSPECTION HANDBOOK - TOLERANCES AND MEASURING METHODS FOR UNASSEMBLED SPUR AND HELICAL GEARS (INCLUDING METRIC EQUIVALENTS) |
| AGMA 2015-2 : A | GEAR TOOTH FLANK TOLERANCE CLASSIFICATION SYSTEM - DEFINITIONS AND ALLOWABLE VALUES OF DOUBLE FLANK RADIAL COMPOSITE DEVIATIONS |
| AGMA 2116 : A | EVALUATION OF DOUBLE FLANK TESTERS FOR RADIAL COMPOSITE MEASUREMENT OF GEARS |
| ISO/TR 10064-2:1996 | Code of inspection practice — Part 2: Inspection related to radial composite deviations, runout, tooth thickness and backlash |
| AGMA 2002 : B | TOOTH THICKNESS AND BACKLASH MEASUREMENT OF CYLINDRICAL INVOLUTE GEARING |
| ISO 53:1998 | Cylindrical gears for general and heavy engineering — Standard basic rack tooth profile |
| ISO/TR 10064-4:1998 | Code of inspection practice — Part 4: Recommendations relative to surface texture and tooth contact pattern checking |
| ISO 54:1996 | Cylindrical gears for general engineering and for heavy engineering — Modules |
| AGMA 915-3 : A1999(R2017) | INSPECTION PRACTICES - GEAR BLANKS, SHAFT CENTER DISTANCE AND PARALLELISM |
| AGMA 1012 : 2005 | GEAR NOMENCLATURE, DEFINITIONS OF TERMS WITH SYMBOLS |