AS 1237.2-2002
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Plain washers for metric bolts, screws and nuts for general purposes - Tolerances
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
01-01-2002
30-06-2017
Specifies the tolerances for the principle fasteners of plain washers of product grades A and C for use with metric bolts, screws, studs and nuts with nominal thread diameters from 1 mm to 150 mm inclusive. This Standard is identical with and has been reproduced from ISO 4759-3:2000.
| Committee |
ME-029
|
| DocumentType |
Standard
|
| ISBN |
0 7337 4847 3
|
| Pages |
6
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes | |
| UnderRevision |
This part of ISO 4759 establishes a selection of tolerances for use in the preparation of ISO product standards for punched plain washers of product grades A and C, for use with bolts, screws and nuts of nominal thread diameters of from 1 mm to 150 mm inclusive.It is recommended that these tolerances also be used for non-standard washers.NOTE The product grade refers to the quality of the product and to the size of the tolerances.Annex A (informative) presents tolerances taken from ISO 286-1 and ISO 286-2.
| Standards | Relationship |
| ISO 4759-3:2000 | Identical |
First published as part of AS 1237-1973.
Revised and redesignated in part as AS 1237.2-2002.
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.