AS 1448-2007
Withdrawn
Carbon steel and carbon-manganese steels - Forgings (ruling section 300 mm maximum)
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
22-05-2007
30-06-2017
Specifies the requirements for carbon steel and carbon-manganese steel forgings for general engineering purposes with ruling section up to and including 300 mm.
| Committee |
MT-001
|
| DocumentType |
Standard
|
| ISBN |
0 7337 8247 7
|
| Pages |
13
|
| ProductNote |
Withdrawn 28-06-2017.
|
| PublisherName |
Standards Australia
|
| Status |
Withdrawn
|
| Supersedes |
This Standard specifies requirements for carbon steel and carbon-manganese steel forgings for general engineering purposes with ruling section up to and including 300 mm. The Standard provides for the supply of forgings on the following basis:(a) Chemical composition only, as specified in Tables 1 to 4.(b) Chemical composition as specified in Tables 1 to 4, and hardness or other mechanical properties in any heat-treated condition, as negotiated at the time of enquiry and/or order.(c) Chemical composition and mechanical properties in the normalized or normalized and tempered condition as specified in Table 5.NOTES:1 For guidance on purchasing requirements refer to Appendix A.2 To demonstrate a means of compliance to the Standard refer to Appendix B.
Originated as AS G30-1970.
Previous edition AS 1448-1981.
Third edition 2007.
This standard has been withdrawn and is no longer current. No replacement edition is available.
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.