AS 2338-1980
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Preferred dimensions of wrought metal products
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
01-01-1980
30-06-2017
Sets out preferred sizes of wrought metal products manufactured from steel (hot rolled and bright), copper and copper alloys, aluminium and aluminium alloys, zinc and zinc alloys. It applies to round, square and rectangular metal products conventionally known as rod, wire and bar, and to flat metal products conventionally known as plate, sheet, strip and foil. An appendix provides information on preferred sizes and guidance on selection of sizes.
| Committee |
PL-027
|
| DocumentType |
Standard
|
| ISBN |
0 7262 1866 9
|
| Pages |
9
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes | |
| UnderRevision |
This standard establishes preferred sizes of wrought metal products manufactured from steel (hot-rolled and bright), copper, copper alloys, aluminium, aluminium alloys, zinc and zinc alloys. It applies to round, square, hexagonal and rectangular metal products conventionally known as rod, wire and bar, and to flat metal products conventionally known as plate, sheet, strip and foil. NOTES:1. For the purposes of this standard, 'bright steel' is intended to cover cold-drawn, cold-sized and cold-finished steel.2. Information on preferred sizes is given in Appendix A.
Reconfirmed 1993
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.