AS/NZS 1867:1997
Current
Aluminium and aluminium alloys - Drawn tubes (Reconfirmed 2020)
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
05-08-1997
Specifies requirements for wrought aluminium and aluminium alloy drawn tube for general engineering purposes. Chemical composition and tensile properties are specified, and allowable tolerances on dimensions included. Included are two appendices, one provides guidelines on information to be supplied by the purchaser at the time of enquiry or order, the other lists fabrication characteristics and application data.
| Committee |
MT-003
|
| DocumentType |
Standard
|
| ISBN |
0 7337 1220 7
|
| Pages |
21
|
| ProductNote |
Reconfirmed 21/08/2020.
This standard has been reconfirmed in Australia in 2020 and remains current in New Zealand. Reconfirmation Notice 21/08/2020 |
| PublisherName |
Standards Australia
|
| Status |
Current
|
| Supersedes |
SCOPE This Standard specifies requirements for wrought aluminium and aluminium alloy drawn tube for general engineering purposes.NOTES:1 Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in the purchasing guidelines set out in Appendix A.2 Typical fabrication characteristics and application data for wrought aluminium and aluminium alloys are given in Appendix B.
Originated in Australia as AS H72-1963.
Previous edition AS 1867-1986.
Jointly revised and designated AS/NZS 1867:1997.
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.