• Shopping Cart
    There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert
Meet Inform Select. Always-on access to the Standards your organisation relies on. Explore Inform Select

AS/NZS 3580.9.10:2006

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Methods for sampling and analysis of ambient air - Part 9.10: Determination of suspended particulate matter - PM (sub)2.5(/sub) low volume sampler - Gravimetric method

Available format(s)

Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users

Language(s)

English

Published date

07-07-2006

Superseded date

30-06-2017

Superseded by

AS 3580.9.10:2017

£39.80
Excluding VAT

Sets out a standard method for determining suspended particulate matter with an equivalent aerodynamic diameter of less than 2.5 micrometre utilizing a low volume sampler and size selective inlet.

Committee
EV-007
DocumentType
Standard
ISBN
0 7337 7602 7
Pages
10
PublisherName
Standards Australia
Status
Superseded
SupersededBy
Supersedes
UnderRevision

This Standard sets out the gravimetric determination of PM (sub)2.5 in ambient air utilizing low volume sequential and non-sequential samplers equipped with size selective inlets. The method provides a measure of mean concentration of PM (sub)2.5 in units of micrograms per cubic metre ug/m3, normally sampled over a 24 h period. This method may be used to collect particle samples for subsequent physical or chemical analysis.NOTE: Sampling is normally of 24 h duration to average out diurnal variations. Provided that the mass of the filter is determined under carefully controlled laboratory conditions, mean concentrations of 5 ug/m3 (3 L/min sample flow rate) or 1 ug/m3 (16.7 L/min sample flow rate) and greater may be determined, based on a 24 h sampling period.

First published as AS/NZS 3580.9.10:2006.

AS 2922-1987 Ambient air - Guide for the siting of sampling units
AS/NZS 3760:2003 In-service safety inspection and testing of electrical equipment
AS ISO/IEC 17025-2005 General requirements for the competence of testing and calibration laboratories (Reconfirmed 2016)

AS/NZS 3580.1.1:2016 Methods for sampling and analysis of ambient air Guide to siting air monitoring equipment
AS/NZS 3580.1.1:2007 Methods for sampling and analysis of ambient air Guide to siting air monitoring equipment

£39.80
Excluding VAT