AS/NZS 3718:1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Water supply - Metal-bodied taps - Specified by performance
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
05-05-1997
29-05-2024
Specifies requirements for metal-bodied draw-off taps, mixing taps mechanical (non-thermostatic) and delivery taps in the range of nominal sizes from DN 6 to DN 50 inclusive with continuous working pressures not exceeding 1.4 MPa and continuous operating temperatures not exceeding 80 degrees Celsius.
| Committee |
WS-001
|
| DocumentType |
Standard
|
| ISBN |
0 7337 1127 8
|
| Pages |
38
|
| PublisherName |
Standards Australia
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes | |
| UnderRevision |
This Standard specifies requirements for copper alloy taps, mixing taps mechanical (non-thermostatic), and tap sets in a range of nominal sizes from DN 6 to DN 50 inclusive with continuous working pressures not exceeding 1.4 MPa and continuous operating temperatures not exceeding 80C.It also specifies requirements for outlets which are an integral part of a tap or mixing tap and the requirements for tapset breaching piece assemblies.Requirements for taps with integral backflow prevention devices are specified in AS 2845.1. Integral pop-up wastes, components and accessories supplied as part of a tap do not require separate certification.Outlets which are a removable part of a tap or mixing tap are currently not covered by this Standard but will become part of this Standard from 1st January 2000.
First published as AS B1-1928T.
Revised and redesignated as AS B35-1931.
Revised and redesignated as AS 1718-1975.
Revised and redesignated (in part) as AS 3718-1988.
Second edition 1990.
Third edition 1992.
Jointly revised and designated AS/NZS 3718:1997.
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.