AS/NZS 61000.4.3:1999

1 - AS/NZS 61000.4.3:1999 ELECTROMAGNETIC COMPATIBILITY (EMC) - TESTING AND MEASUREMENT TECHNIQUES-RADIATED RADIO-FREQUENCY....
4 - PREFACE
5 - CONTENTS
7 - 1 Scope and object
7 - 2 Normative references
8 - 3 General
8 - 4 Definitions
10 - 5 Test levels
10 - 6 Test equipment
11 - 6.1 Description of the test facility
12 - 6.2 Calibration of field
13 - 7 Test set-up
14 - 7.1 Arrangement of table-top equipment
14 - 7.2 Arrangement of floor-standing equipment
14 - 7.3 Arrangement of wiring
15 - 8 Test procedures
16 - 9 Test results and test report
24 - Annex A - Portable transceivers (walkie-talkies)
25 - Annex B - Field generating antennas
25 - B.1 Biconical antenna (20 MHz - 300 MHz)
25 - B.2 Log-periodic antenna (80MHz - 1 000 MHz)
25 - B.3 Circularly polarized antenna
26 - Annex C - Use of anechoic chambers
27 - Annex D - Other test methods - TEM cells and striplines
28 - Annex E - Other test facilities
28 - E.1 Partially lined screened rooms
28 - E.2 Open area test site
29 - Annex F - Selection of the test levels
30 - Annex G - Special measures
31 - Annex H - Selection of test methods
33 - Amendment 1

Specifies the immunity of electrical and electronic equipment to radiated electromagnetic energy. Establishes test levels and the required test procedures. Establishes a common reference for evaluating the performance of electrical and electronic equipment when subjected to radio-frequency electromagnetic fields. The Standard is one of a series of Standards applicable to electromagnetic compatibility. This Standard is identical with and has been reproduced from IEC 61000-4-3:1995, including Amendment 1:1998.

This section of IEC 1000-4 is applicable to the immunity of electrical and electronic equipment to radiated electromagnetic energy. It establishes test levels and the required test procedures. The object of this section is to establish a common reference for evaluating the performance of electrical and electronic equipment when subjected to radio-frequency electromagnetic fields.NOTE - Test methods are defined in this section for measuring the effect that electromagnetic radiation has on the equipment concerned. The simulation and measurement of electromagnetic radiation is not adequately exact for quantitative determination of effects. The test methods defined are structured for the primary objective of establishing adequate repeatability of results at various test facilities for qualitative analysis of effects.This section does not intend to specify the tests to be applied to particular apparatus or systems. Its main aim is to give a general basic reference to all concerned product committees of the IEC. The product committees (or users and manufacturers of equipment) remain responsible for the appropriate choice of the tests and the severity level to be applied to their equipment.

First published as AS/NZS 61000.4.3:1999.