Customer Support: +44 (0)203 327 3140

Your region & currency

United Kingdom English(GB)

Pricing in GBP £

Local sites

  • Shopping Cart
    There are no items in your cart

We noticed you are browsing from United States. Switch to our United States site for local pricing in USD.

Dismiss alert

ASME B89.1.9 : 2002 : R2007

Superseded

Superseded

View Superseded by

GAGE BLOCKS

Available format(s)

PDF

Language(s)

English

Published date

01-01-2012

Superseded date

21-08-2021

Summarise this standard

Foreword
Committee Roster
Correspondence with the B89 Committee
0 Introduction
1 Scope
2 Normative References
3 Definitions
4 Nomenclature of Faces
5 Basis of Measurement, Traceability, and Reference Condition
6 General Dimensions, Material Properties, and Marking
7 Metrological Requirements
8 Calibration of Gage Blocks
Nonmandatory Appendices
A - Grade 00
B - Differences Between Former GGG-G-15C and This Standard
C - Testing Methods
D - Possible Sources of Measurement Uncertainty
E - Thin Gage Blocks (Less Than 1.0 mm or 0.040 in.)
F - Use and Care of Gage Blocks
G - Gage Block Sizes and Sets
H - Gage Block Accessories
I - Gravity and Atmospheric Effects on Gage Blocks

Describes the most important design and metrological characteristics of gage blocks with a rectangular or square cross-section and a nominal length l[n] ranging from 0.5 mm to 1000 mm for metric sizes and 0.010 in. to 40 in. for inch sizes.

DevelopmentNote
Supersedes ASME B89.1.9M. (02/2004)
DocumentType
Standard
Pages
47
ProductNote
Reconfirmed 2007
PublisherName
American Society of Mechanical Engineers
Status
Superseded
SupersededBy
Supersedes

⚠

A newer version of this standard is available.

View Current Edition