Standard Specification for Phosphor Bronze Plate, Sheet, Strip, and Rolled Bar

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-10-2004

Publisher

American Society for Testing and Materials

1.1 This specification establishes copper-tin alloy (phosphor bronze), copper-tin-lead alloy (leaded phosphor bronze), and copper-tin-lead-zinc alloy (bearing bronze), plate, sheet, strip, and rolled bar. The phosphor bronzes commonly are used for deep drawing into bellows and stamping and forming into spring devices and into terminals and connectors for electrical apparatus because they combine high strength with high elongation. The leaded phosphor bronzes are used where strength, corrosion resistance, and machinability are required. The bearing bronze is used in bushings, bearings, and load-bearing thrust washers. The following alloys are covered:

SAE Specification CA 521 conforms to the requirements of UNS No. C52100.

Copper Alloy UNS No.	Nominal Composition, %	Previously Used Designation
Copper	Tin	Zinc	Lead

C51000	95	5	. . .	. . .	A1
C51100	96	4	. . .	. . .	A
C51180	96	4	. . .	. . .	. . .
C51900	94	6	. . .	. . .
C52100	92	8	. . .	. . .	C
C52180	92	8	. . .	. . .	. . .
C52400	90	10	. . .	. . .	D
C53400	94	5	. . .	1	B1
C54400	88	4	4	4	B2

Note 1—All of the above alloys contain small amounts of phosphorus, used as a deoxidant in melting, and to enhance the mechanical properties.

1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Committee	B 05
DocumentType	Standard
Pages	7
PublisherName	American Society for Testing and Materials
Status	NA
SupersededBy	ASTM B 103/B103M : 2004 : EDT 1
Supersedes	ASTM B 103/B103M : 1998 : EDT 2