ASTM D 2319/D2319M : 2020
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Softening Point of Pitch (Cube-in-Air Method)
English
01-06-2020
10-06-2020
| Committee |
D 02
|
| DocumentType |
Test Method
|
| Pages |
3
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method covers the determination of the softening point above 80 °C [176 °F] of pitch. Test Method D3104 gives comparable results.
1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 4296 : 2024 | Standard Practice for Sampling Pitch |
| ASTM D 4296 : 2024 : REV A | Standard Practice for Sampling Pitch |
| ASTM E 1 : 2014 : R2025 | Standard Specification for ASTM Liquid-in-Glass Thermometers |
| ASTM D 3104 : 2025 | Standard Test Method for Softening Point of Pitches (Mettler Softening Point Method) |
| ASTM D 61 : 2024 | Standard Test Method for Softening Point of Pitches (Cube-in-Water Method) |
| ASTM E 1 : 2014 : R2020 | Standard Specification for ASTM Liquid-in-Glass Thermometers |
| ASTM D 61 : 2015 : R2019 | Standard Test Method for Softening Point of Pitches (Cube-in-Water Method) |
| ASTM D 4296 : 2018 | Standard Practice for Sampling Pitch |
| ASTM D 3104 : 2014 : REV A : R2018 | Standard Test Method for Softening Point of Pitches (Mettler Softening Point Method) |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.