Standard Specification for Filament-Wound “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

11-10-2023

Publisher

American Society for Testing and Materials

1.1This specification covers machine-made reinforced thermosetting resin pressure pipe (RTRP) manufactured by the filament winding process up to 60 in. nominal size. Included are a classification system and requirements for materials, mechanical properties, dimensions, performance, methods of test, and marking.

1.2The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are provided for information purposes only.

1.3The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1:The term “fiberglass pipe” as described in Section 3 of this specification applies to both reinforced thermosetting resin pipe (RTRP) and reinforced polymer mortar pipe (RPMP). This specification covers only reinforced thermosetting resin pipe (RTRP).

Note 2:There is no known ISO equivalent to this standard.

Note 3:This specification is applicable to RTRP where the ratio of outside diameter to wall thickness is 10:1 or more.

Note 4:For the purposes of this standard, polymer does not include natural polymers.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 20
DocumentType	Standard
Pages	6
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 2996 : 2017

ASTM D 3299 : 2018	Standard Specification for Filament-Wound Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
ASTM C 1847 : 2021	Standard Specification for Direct Buried Pre-Insulated and Jacketed Polyurethane Bonded Low Temperature Hot Water Piping Systems
ASTM D 5421 : 2023	Standard Specification for Contact Molded “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Flanges
ASTM F 1155 : 2010 : R2019	Standard Practice for Selection and Application of Piping System Materials
ASTM D 4097 : 2019	Standard Specification for Contact-Molded Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
ASTM D 5685 : 2019	Standard Specification for “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pressure Pipe Fittings

ASTM D 883 : 2023	Standard Terminology Relating to Plastics
ASTM D 883 : 2024	Standard Terminology Relating to Plastics
ASTM D 883 : 2022	Standard Terminology Relating to Plastics
ASTM D 1600 : 2018	Standard Terminology for Abbreviated Terms Relating to Plastics (Withdrawn 2024)