BIS IS 1500-1 : 2013
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
METALLIC MATERIALS - BRINELL HARDNESS TEST - PART 1: TEST METHOD
09-10-2013
02-07-2019
NATIONAL FOREWORD
1 Scope
2 Normative references
3 Principle
4 Symbols and abbreviated terms
5 Apparatus
6 Test piece
7 Procedure
8 Uncertainty of the results
9 Test report
Annex A (informative) - Procedure for periodic checking
of the testing machine by the user
Annex B (normative) - Minimum thickness of the test
piece in relation to the mean diameter of indentation
Annex C (informative) - Uncertainty of the measured
hardness values
Bibliography
Describes the method for the Brinell hardness test for metallic materials and is applicable up to the limit of 650 HBW.
| Committee |
MTD 3
|
| DevelopmentNote |
Supersedes BIS IS 1500. (09/2013)
|
| DocumentType |
Standard
|
| PublisherName |
Bureau of Indian Standards
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| BIS IS 1500-2 : 2013 | METALLIC MATERIALS - BRINELL HARDNESS TEST - PART 2: VERIFICATION AND CALIBRATION OF TESTING MACHINES |
| BIS IS 6911 : 2017 AMD 1 2017 | STAINLESS STEEL PLATE, SHEET AND STRIP - SPECIFICATION |
| BIS IS 1500-3 : 2013 | METALLIC MATERIALS - BRINELL HARDNESS TEST - PART 3: CALIBRATION OF REFERENCE BLOCKS |
| ISO 4498-1:1990 | Sintered metal materials, excluding hardmetals — Determination of apparent hardness — Part 1: Materials of essentially uniform section hardness |
| BIS IS 1500-4 : 2013 | METALLIC MATERIALS - BRINELL HARDNESS TEST - PART 4: TABLE OF HARDNESS VALUES |
| BIS IS 1500-2 : 2013 | METALLIC MATERIALS - BRINELL HARDNESS TEST - PART 2: VERIFICATION AND CALIBRATION OF TESTING MACHINES |
| ISO 6506-4:2014 | Metallic materials — Brinell hardness test — Part 4: Table of hardness values |
| ISO 6506-2:2017 | Metallic materials — Brinell hardness test — Part 2: Verification and calibration of testing machines |
| BIS IS 15703 : 2006 | SINTERED METAL MATERIALS, EXCLUDING HARDMETALS - DETERMINATION OF APPARENT HARDNESS AND MICROHARDNESS |
| ISO/IEC Guide 98-3:2008 | Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995) |