BS 3894-1:1965
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Method for converting elongation values for steel Carbon and low alloy steels
Hardcopy , PDF
English
03-06-1965
15-09-1999
Cooperating organizations
Foreword
Method
Section one. General
1. Scope
2. Symbols
3. Definitions
4. Basic formula
Section two. Application of the factors and tables
5. Conversion from one proportional gauge length to
another proportional gauge length
6. Conversion from one non-proportional gauge length to
another non-proportional gauge length for test
pieces of equal cross-sectional area
7. Conversion from a proportional gauge length to a
non-proportional gauge length
8. Conversion from a non-proportional gauge length to
another non-proportional gauge length for test
pieces of different cross-sectional areas
9. Use of charts 1 and 2
Section three. Tables
1. Conversion factors: proportional gauge lengths
2. Conversion factors: non-proportional gauge lengths
3. Conversion factors from 5.65 square root So to
non-proportional gauge lengths
4. Elongation values on 5.65 square root So
corresponding to those obtained on 4 square root So
gauge length
5. Elongation values on 5.65 square root So
corresponding to those obtained on 2 inch gauge
length
6. Elongation values on 5.65 square root So
corresponding to those obtained on 4 inch gauge
length
7. Elongation values on 5.65 square root So
corresponding to those obtained on 8 inch gauge
length
8. Elongation values on 4 square root So corresponding
to those obtained on 2 inch gauge length
9. Elongation values on 4 square root So corresponding
to those obtained on 4 inch gauge length
10. Elongation values on 4 square root So corresponding
to those obtained on 8 inch gauge length
Chart 1. Elongation conversion chart: 5.65 square root
So to 2 inch and 8 inch gauge lengths
Chart 2. Elongation conversion chart: 4 square root So
to 2 inch and 8 inch gauge lengths
Formula for conversion; conversion factors for obtaining equivalent values on different proportional and non-proportional gauge lengths; tables of actual conversions of values obtained on 4 √S0 and 5.65 √S0, 2 in, 4 in and 8 in gauge lengths to the equivalent on another gauge length; monogram charts to convert values on 4 √S0 or 5.56 √S0 to equivalent on 2 in, 4 in or 8 in gauge lengths.
| Committee |
ISE/101
|
| DocumentType |
Standard
|
| Pages |
20
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| EURONORM 9 : 1955 | Similar to |
| UNE-EN 12124:2006 | Identical |
| UNE 60560-2:2003 | Identical |
| UNE-EN ISO 12213-2:2005 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.