BS 907:2008
Current
The latest, up-to-date edition.
Specification for dial gauges for linear measurement
Hardcopy , PDF
English
31-08-2009
Foreword
1 Scope
2 Terms and definitions
3 General features of design
4 Dial
5 Pointer
6 Revolution counter
7 Plunger
8 Contact point
9 Performance
10 Packing
11 Marking
Annexes
Annex A (informative) - Recommended dimensions for dial gauges
Annex B (informative) - Notes on methods of testing dial gauges
Annex C (informative) - Notes on the care and use of dial gauges
Bibliography
Defines requirements for dial gauges with the plunger movement parallel to the plane of the dial.
| Committee |
TPR/1
|
| DevelopmentNote |
Supersedes BS 907(1965) and 08/30178087 DC. (11/2008) Earlier was replaced in error, now has been reinstated as current/partially replaced by BSI. (10/2015)
|
| DocumentType |
Standard
|
| Pages |
20
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| SupersededBy | |
| Supersedes |
This British Standard specifies requirements for dial gauges with the plunger movement parallel to the plane of the dial.
The standard is applicable to gauges having dial diameters from 47.6 mm or 17⁄8 in to 63.5 mm or 21⁄2 in, as measured from the outside of the scale marks, and scale divisions of 0.01 mm, 0.001 in (sometimes sub-divided into half divisions of 0.000 5 in, in which case they are commonly designated “0.000 5 in gauges”) or 0.000 1 in.
NOTE 1 Attention is drawn to the fact that the metric dimensions are not necessarily direct conversions of the imperial dimensions.
NOTE 2 Recommended dimensions for dial gauges are given in Annex A (Figure A.1) and notes on methods of testing and on the care and use of dial gauges are given in Annex B and Annex C respectively.
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.