BS EN 133200:1999
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Harmonized system of quality assessment for electronic components. Sectional specification:passive filter units for electromagnetic interference suppression (filters for which safety tests are required)
Hardcopy , PDF
English
15-10-1999
19-08-2005
BS EN 60939-2:2005+A1:2023
BS EN 60939-1:2005
BS EN 60939-2:2005
Foreword
1. GENERAL
1.1 Scope
1.2 Related documents
1.3 Information to be given in a detail specification
1.4 Terminology
1.5 Marking
2. PREFERRED RATINGS AND CHARACTERISTICS
2.1 Preferred characteristics
2.2 Preferred values of ratings
3. QUALITY ASSESSMENT PROCEDURES
3.1 Primary stage of manufacture
3.2 Structurally similar filters
3.3 Certified records of released lots
3.4 Approval testing
3.5 Quality conformance inspection
4. TEST AND MEASUREMENT PROCEDURES
4.0 Capacitance and tan delta measurements
4.1 Visual examination and check of dimensions
4.2 Voltage proof
4.3 Insulation resistance
4.4 D.c. line resistance or voltage drop at rated current
4.5 Insertion loss
4.6 Resistance
4.7 Robustness of terminations
4.8 Resistance to soldering heat
4.9 Solderability
4.10 Rapid change of temperature
4.11 Vibration
4.12 Bump
4.13 Shock
4.14 Container sealing
4.15 Climatic sequence
4.16 Damp heat, steady state
4.17 Temperature rise
4.18 Impulse voltage
4.19 Endurance
4.20 Charge and discharge
4.21 Passive flammability
4.22 Current overload
4.23 Solvent resistance of the marking
4.24 Component solvent resistance
Annex A Test schedule for qualification approval
Annex B Test schedule for safety requirements only
Annex C Circuit for the impulse voltage test
Annex D Suitable circuit for the endurance test
Annex E Declaration of design (normative)
Defines passive filter units for electromagnetic interference suppression which fall within the scope of the Generic Specification EN 133000. Specified according to this specification will either be connected to mains supplies, when compliance with the mandatory tests of Table 2 is necessary, or used on other circuit positions where the equipment specification prescribes that some or all of these safety tests are required. Applies to those connected to an a.c. mains or other supply with a nominal voltage not exceeding 1000 V a.c. (r.m.s.) or 1000 V d.c. with a nominal frequency not exceeding 400 Hz.
| Committee |
W/-
|
| DevelopmentNote |
Supersedes 91/34179 DC. (03/2007)
|
| DocumentType |
Standard
|
| Pages |
44
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| I.S. EN 133200:1995 | Identical |
| DIN EN 133200 : 2000 | Identical |
| EN 133200:1999 | Identical |
| UNE-EN 133200:1999 | Equivalent |
A newer version of this standard is available.
View Current Edition View Current Edition View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.