BS EN 13463-5:2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Non-electrical equipment intended for use in potentially explosive atmospheres Protection by constructional safety \'c\'
Hardcopy , PDF
English
01-03-2012
30-06-2016
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Requirements for moving parts
6 Requirements for bearings
7 Requirements for power transmission systems
8 Requirements for brakes and braking systems
9 Requirements for springs and absorbing elements
10 Requirements for conveyor belts
11 Marking
Annex A (informative) - Examples for an ignition hazard
assessment report for typical equipment parts and
potential ignition sources
Annex B (normative) - Test requirements
Annex C (informative) - Significant technical changes
between this European Standard and EN 13463-5:2003
Annex ZA (informative) - Relationship between this European
Standard and the Essential Requirements of EU
Directive 94/9/EC
Bibliography
Describes the requirements for the design and construction of non-electrical equipment, intended for use in potentially explosive atmospheres, protected by the type of protection Constructional Safety 'c'.
| Committee |
EXL/23
|
| DevelopmentNote |
Supersedes 00/541592 DC. (12/2003) Supersedes 09/30199364 DC. (02/2012)
|
| DocumentType |
Standard
|
| Pages |
46
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This European Standard specifies the requirements for the design and construction of non-electrical equipment, intended for use in potentially explosive atmospheres, protected by the type of protection Constructional Safety \'c\'.
1.2 This European Standard supplements the requirements in EN 13463-1, the contents of which also apply in full to equipment constructed in accordance with this European Standard.
1.3 The type of ignition protection described in the standard can be used either on its own or in combination with other types of ignition protection to meet the requirements for equipment of Group I, category M2 or Group II, categories 1 and 2 depending on the ignition hazard assessment in EN 13463-1. Type of ignition protection \'c\' is not applicable for Group I for M1. These requirements are specified in EN 50303.
NOTE Most category 3 equipment, only needs to meet the requirements of EN 13463-1, but some category 3 equipment may have to meet the requirements of this European Standard for some of the ignition sources identified in the ignition hazard assessment.
| Standards | Relationship |
| NEN EN 13463-5 : 2011 | Identical |
| DIN EN 13463-5:2011-10 | Identical |
| I.S. EN 13463-5:2011 | Identical |
| EN 13463-5:2011 | Identical |
| NF EN 13463-5 : 2011 | Identical |
| NS EN 13463-5 : 2011 | Identical |
| NBN EN 13463-5 : 2011 | Identical |
| UNE-EN 13463-5:2013 | Identical |
| DIN EN 13463-5:2004-03 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.