BS EN 14870-1:2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Petroleum and natural gas industries. Induction bends, fittings and flanges for pipeline transportation systems Induction bends
Hardcopy , PDF
English
31-07-2011
14-07-2023
Foreword
Introduction
1 Scope
2 Conformance
3 Normative references
4 Terms and definitions
5 Symbols and abbreviated terms
6 Designation
7 Pressure rating and design
8 Information that shall be supplied by the purchaser
9 Manufacturing
10 Testing and inspection
11 Inspection document
12 Marking
Annex A (normative) - Manufacturing procedure specification
Annex B (normative) - PSL 2S bends ordered for sour service
Bibliography
Describes the technical delivery conditions for bends made by the induction bending process for use in pipeline transportation systems for the petroleum and natural gas industries as defined in ISO 13623.
| Committee |
PSE/17
|
| DevelopmentNote |
Supersedes 99/714367 DC. (11/2004)
|
| DocumentType |
Standard
|
| Pages |
44
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This International Standard specifies the technical delivery conditions for bends made by the induction bending process for use in pipeline transportation systems for the petroleum and natural gas industries as defined in ISO 13623.
This International Standard is applicable to induction bends made from seamless and welded pipe of unalloyed or low-alloy steels.
NOTE These are typically C-Mn steels or low-alloy steels that are appropriate for the corresponding level and grade of line pipe in accordance with ISO 3183.
This International Standard specifies the requirements for the manufacture of two product specification levels (PSLs) of induction bend corresponding to product specification levels given for pipe in ISO 3183.
This International Standard is not applicable to the selection of the induction bend product specification level. It is the responsibility of the purchaser to specify the PSL, based upon the intended use and design requirements; see also ISO 3183:2007, Introduction.
This International Standard is not applicable to pipeline bends made by other manufacturing processes.
On-land supply systems used by the gas supply industry excluding gas infrastructure from the input of gas into the on-shore transmission network up to the inlet connection of gas appliances are excluded from the scope of this standard.
| Standards | Relationship |
| EN 14870-1:2011 | Identical |
| I.S. EN 14870-1:2011 | Identical |
| NS EN 14870-1 : 2011 | Identical |
| NEN EN 14870-1 : 2011 | Identical |
| NF EN 14870-1 : 2012 | Identical |
| ISO 15590-1:2009 | Identical |
| NBN EN 14870-1 : 2011 | Identical |
| DIN EN 14870-1:2011-09 | Equivalent |
| UNE-EN 14870-1:2011 | Equivalent |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.