BS EN ISO 18563-3:2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Non-destructive testing. Characterization and verification of ultrasonic phased array equipment Combined systems
Hardcopy , PDF
English
31-01-2016
10-05-2024
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 General requirements for conformity
6 Modes of operation
7 Equipment required for tests
8 Group 1 tests
9 Group 2 tests
10 System record sheet
Annex A (informative) - Tests to be performed and
their acceptance criteria
Bibliography
Gives methods and acceptance criteria for verifying the performance of combined equipment (i.e. instrument, probe and cables connected).
| Committee |
WEE/46
|
| DevelopmentNote |
Supersedes 14/30279593 DC. (02/2016)
|
| DocumentType |
Standard
|
| Pages |
46
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This part of ISO18563 addresses ultrasonic test systems implementing linear phased array probes, in contact (with or without wedge) or in immersion, with centre frequencies in the range of 0,5MHz-10MHz. It provides methods and acceptance criteria for verifying the performance of combined equipment (i.e. instrument, probe and cables connected). The methods described are suitable for users working under on-site or shop floor conditions. Its purpose is for the verification of the correct operation of the system prior to testing, and also the characterization of sound beams or verification of the absence of degradation of the system. The methods are not intended to prove the suitability of the system for particular applications, but are intended to prove the capability of the combined equipment to generate ultrasonic beams according to the settings used. The calibration of the system for a specific application is outside of the scope of part of ISO18563 and it is intended that it be covered by the test procedure. This part of ISO18563 does not address the following: encircling arrays; series of apertures having a different number of elements; different settings for transmitting and receiving (e.g. active aperture, number of active elements, delays); techniques using post-processing of the signals of individual elements in a more complex manner than a simple delay law (e.g. full matrix capture).
| Standards | Relationship |
| I.S. EN ISO 18563-3:2015 | Equivalent |
| ISO 18563-3:2015 | Identical |
| EN ISO 18563-3:2015 | Identical |
A newer version of this standard is available.
View Current Edition
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.