BS ISO 19072-2:2013
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Road vehicles. Connection interface for pyrotechnic devices, two-way and three-way connections Test methods and general performance requirements
Hardcopy , PDF
English
30-09-2013
10-01-2020
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Functional characteristics of mated
connectors
5 Test sequences
Annex A (normative) - Sealed variant of the
pyrotechnic device/initiator harness
connector assembly
Annex B (normative) - Two-way (without ground)
variant of the pyrotechnic device/initiator
harness connector assembly
Annex C (normative) - Variant without retainer of
the pyrotechnic device/initiator harness
connector assembly
Bibliography
Describes the performance criteria and requirements of a three-way connection interface, including ground connection, linking the pyrotechnic device and harness connector built into a road vehicle.
| Committee |
AUE/16
|
| DevelopmentNote |
Supersedes 06/30137905 DC. (10/2007) Supersedes 12/30265053 DC. (09/2013)
|
| DocumentType |
Standard
|
| Pages |
30
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 19072-2:2013 | Identical |
| ISO 16750-2:2012 | Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 2: Electrical loads |
| ISO 16750-4:2010 | Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 4: Climatic loads |
| ISO 16750-5:2010 | Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 5: Chemical loads |
| ISO 16750-1:2006 | Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 1: General |
| ISO 8092-2:2005 | Road vehicles — Connections for on-board electrical wiring harnesses — Part 2: Definitions, test methods and general performance requirements |
| ISO 20653:2013 | Road vehicles — Degrees of protection (IP code) — Protection of electrical equipment against foreign objects, water and access |
| ISO 16750-3:2012 | Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 3: Mechanical loads |
| ISO 178:2010 | Plastics — Determination of flexural properties |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.