BS ISO 24213:2017
Current
The latest, up-to-date edition.
Metallic materials. Sheet and strip. Method for springback evaluation in stretch bending
Hardcopy , PDF
English
29-06-2017
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and designations
5 Principle
6 Test apparatus
7 Test piece
8 Procedure
9 Test report
Annex A (normative) - Method for calculating blank
holding pressure
Annex B (normative) - Method for calculating nominal
tensile stress
Annex C (normative) - Device for determining radius
of curvature using a dial gauge
Bibliography
Describes a method for evaluating the amount of springback of sheets of metallic materials known to exhibit large amounts of springback subjected to plane-strain stretch bending, which is a typical deformation mode generated in press-formed panels.
| Committee |
ISE/101/1
|
| DevelopmentNote |
Supersedes 07/30161983 DC. (04/2008)
|
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This document specifies a method for evaluating the amount of springback of sheets of metallic materials known to exhibit large amounts of springback subjected to plane-strain stretch bending, which is a typical deformation mode generated in press-formed panels. By using this method, the amount of springback under stretch bending is evaluated accurately and quantitatively[1][2].
| Standards | Relationship |
| ISO 24213:2017 | Identical |
| ISO 80000-1:2009 | Quantities and units — Part 1: General |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.