BS ISO 6402-1:1990
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Plastics. Impact resistant acrylonitrile/styrene moulding and extrusion materials (ASA, AES, ACS), excluding butadiene-modified materials Designation
Hardcopy , PDF
English
15-08-1995
15-11-1999
No contents section
Establishes a system of designation for impact-resistant acrylonitrile/styrene (or substituted styrene) thermoplastic materials, excluding butadiene-modified materials. Does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application or method of processing. BS AMD 10651 RENUMBERS THIS STANDARD.
| Committee |
PRI/82
|
| DevelopmentNote |
Renumbered and superseded by BS EN ISO 6402-1 (11/2002)
|
| DocumentType |
Standard
|
| Pages |
12
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 6402-1:2002 | Identical |
| ISO 6402-1:1990 | Identical |
| ISO 1656:2014 | Rubber, raw natural, and rubber latex, natural — Determination of nitrogen content |
| ISO 293:2004 | Plastics — Compression moulding of test specimens of thermoplastic materials |
| ISO 180:2000 | Plastics — Determination of Izod impact strength |
| ISO 306:2013 | Plastics — Thermoplastic materials — Determination of Vicat softening temperature (VST) |
| ISO 8328:1989 | Plastics — Amorphous thermoplastic moulding materials — Determination of maximum reversion |
| ISO 2557-1:1989 | Plastics — Amorphous thermoplastics — Preparation of test specimens with a specified maximum reversion — Part 1: Bars |
| ISO 1043-2:2011 | Plastics — Symbols and abbreviated terms — Part 2: Fillers and reinforcing materials |
| ISO 4607:1978 | Plastics — Methods of exposure to natural weathering |
| ISO 178:2010 | Plastics — Determination of flexural properties |
| ISO 1043-1:2011 | Plastics — Symbols and abbreviated terms — Part 1: Basic polymers and their special characteristics |
| ISO 1133:2005 | Plastics — Determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastics |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.