DEFSTAN 00-970(PT1)SEC2/8(2012) : 2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 1: FIXED WING - SECTION 2 - FLIGHT
Hardcopy , PDF
07-01-2013
English
01-01-2012
Preface
SECTION 2 - FLIGHT
2.0 Introduction and Abbreviations
2.1 General requirements and definitions
2.2 General handling flight test requirements
2.3 Ground handling
2.4 Take off and initial climb
2.5 Circuit, approach, landing and overshoot
2.6 Longitudinal trim, stability and control
2.7 Demonstration of limits of flight and manoeuvre envelopes
2.8 Lateral and directional trim, stability and control
2.9 Rapid rolling/roll coupling
2.10 Behaviour at or near the stall
2.11 Lift boundaries
2.12 Spinning
2.13 Aerobatic manoeuvres
2.14 Effect of engine failures
2.15 Effect of system failures
2.16 Automatic flight control systems and flight directors
2.17 General handling
2.18 Air to air refuelling
2.19 Handling tests specific to VSTOL aeroplanes
2.20 Handling performance in icing conditions
2.21 Longitudinal flying qualities
2.22 Lateral and directional flying qualities
2.23 Requirements for structural and equipment exposure to
noise and vibration
2.24 Stalling, post-stall gyrations and spins and miscellaneous
flying qualities
2.25 Handling requirements for VSTOL aeroplanes
SECTION 2 - TABLES
SUPPLEMENTS
Leaflet 0 to 66
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.