• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

DEFSTAN 59-41(PT3)SEC1/1(1998) : INTERIM

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

ELECTROMAGNETIC COMPATIBILITY - TECHNICAL REQUIREMENTS TEST METHODS AND LIMITS - MAN WORN, MAN PORTABLE EQUIPMENT

Superseded date

05-04-1999

Published date

12-01-2013

    Preface
0 Introduction
1 WARNING
2 Precedence of requirements
3 Format
4 General test requirements
5 Classification of equipment and limits
6 Test methods and limits
    Conducted emission DCE02.1
    Conducted susceptibility DCS02.1
                             DCS03.1
    Electrostatic discharge DCS10.1
    Radiated emissions DRE01.1
                             DRE02.1
                             DRE03.1
    Radiated susceptibility DRS01.1
                             DRS02.1
Tables
Table 1 Receiver bandwidths
Table 2 Examples of basic and logarithmic unit relationships
Table 3 Test methods
Table 4 DCS02.1 Performance specification for CW injection
          probes
Table 5 DCS02.1 Limits for induced current on man worn/
          portable EUT wiring
Table 6 ESD generator output requirements
Table 7 Outline technical characteristics of ESD generator
Table 8 DCS10.1 Application of charging voltage by equipment
          category
Figures
Figure 1 Suggested screened room layout for man worn/ man
          portable equipment
Figure 2 DCE02.1 Typical test configurations
Figure 3 DCE02.1 Limits for man worn, man portable land based
          equipment
Figure 4 DCS02.1 Typical test configurations
Figure 5 DCS02.1 Limits in terms of current to be induced into
          the calibration jig for man worn, man portable land
          based equipment
Figure 6 DCS03.1 Typical test configurations
Figure 7 DCS03.1 Limits for man worn, man portable land based
          equipment
Figure 8 DCS10.1 ESD calibration arrangement
Figure 9 DCS10.1 Simplified diagram ESD generator
Figure 10 DCS10.1 ESD generator discharge tip geometry
Figure 11 DCS10.1 Typical ESD waveform
Figure 12 DCS10.1 Typical test configurations
Figure 13 DRE01.1 Typical test configurations
Figure 14 DRE01.1 Limits for man worn, man portable land based
          equipment
Figure 15 DRE02.1 Coil arrangements for magnetic emissions
          500 Hz - 250 kHz
Figure 16 DRE02.1 Typical test configurations
Figure 17 DRE02.1 Limits for man worn, man portable land based
          equipment
Figure 18 DRE03.1 Typical test configurations 1.6 MHz - 30 MHz
Figure 19 DRE03.1 Typical test configurations 30 MHz - 76 MHz
Figure 20 DRE03.1 Limits for man worn, man portable land based
          equipment
Figure 21 DRS01.1 Typical test configurations
Figure 22 DRS01.1 Limits for man worn, man portable land based
          equipment
Figure 23 DRS02.1 Typical test configurations
Figure 24 DRS02.1 Limits for man worn, man portable land based
          equipment

Gives the preferred techniques for use in measuring the electromagnetic compatibility characteristics of Man Portable and man worn electronic and electrical equipment to be procured by the Ministry of Defence.

DocumentType
Miscellaneous Product
PublisherName
UK Ministry of Defence Standards
Status
Superseded
SupersededBy

DEFSTAN 59-41(PT4)/3(1996) : 1996 ELECTROMAGNETIC COMPATIBILITY - PART 4: LARGE EQUIPMENT TESTING
DEFSTAN 59-41(PT1)SEC1/6(1995) : 1995 ELECTROMAGNETIC COMPATIBILITY - PART 1: INTRODUCTION - SECTION 1: GENERAL REQUIREMENTS
DEFSTAN 59-41(PT3)/5(1995) : 1995 ELECTROMAGNETIC COMPATIBILITY - PART 3: TECHNICAL REQUIREMENTS TEST METHODS AND LIMITS
DEFSTAN 59-41(PT6)/1(1994) : 1994 ELECTROMAGNETIC COMPATIBILITY - PART 6: CODE OF PRACTICE FOR MILITARY VEHICLES INSTALLATION GUIDELINES
DEFSTAN 59-41(PT5)/1(1995) : 1995
DEFSTAN 59-41(PT7)/1(1995) : 1995 ELECTROMAGNETIC COMPATIBILITY - PART 7: CODE OF PRACTICE FOR HM SHIPS INSTALLATION GUIDELINES
DEFSTAN 59-41(PT1)SEC2/6(1995) : 1995 ELECTROMAGNETIC COMPATIBILITY - PART 1: INTRODUCTION - SECTION 2: GUIDE TO THE SPECIFICATION AND SELECTION OF EMC REQUIREMENTS
DEFSTAN 59-41(PT2)/4(1995) : 1995 ELECTROMAGNETIC COMPATIBILITY - MANAGEMENT AND PLANNING PROCEDURES
DEFSTAN 59-41(PT3)SEC2/1(1998) : INTERIM ELECTROMAGNETIC COMPATIBILITY - PART 3: TECHNICAL REQUIREMENTS TEST METHODS AND LIMITS - SECTION 2: FREE STANDING EQUIPMENT

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.