DIN EN 10259:1997-07
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
COLD-ROLLED STAINLESS STEEL WIDE STRIP AND PLATE/SHEET - TOLERANCES ON DIMENSIONS AND SHAPE
Hardcopy , PDF
English
01-01-1997
01-05-2006
Foreword
1 Scope
2 Normative references
3 Definitions
4 Designation
5 Condition of delivery
6 Preferred thickness and tolerances on thickness
7 Tolerances on width
8 Preferred coil inner diameters
9 Tolerances on length
10 Flatness and edge waviness tolerances
11 Tolerances on out-of-squareness
12 Tolerances on edge camber
13 Ordered format (for sheet/plate)
14 Measurement
Annex A (informative) Bibliography
This standard is included in DIN Handbook 28 E. Applies to cold-rolled stainless, heat resisting and creep resisting steel flat products in thickness up to 6,5 mm, and rolled widths of 600 mm up to 2100 mm, delivered as: - wide strip (coils with a rolled width >= 600 mm), - sheet or plate cut from wide strip, - slit cold-rolled wide strip, - cut lengths obtained from slit cold-rolled wide strip or sheet.
| DevelopmentNote |
Supersedes DIN 59382 E (09/2000)
|
| DocumentType |
Standard
|
| Pages |
14
|
| PublisherName |
German Institute for Standardisation (Deutsches Institut für Normung)
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NBN EN 10259 : 1997 | Identical |
| EN 10259 : 1997 | Identical |
| NEN EN 10259 : 1997 | Identical |
| I.S. EN 10259:1998 | Identical |
| NF EN 10259 : 1997 | Identical |
| NS EN 10259 : 1ED 1997 | Identical |
| BS EN 10259:1997 | Identical |
| EN 10079:2007 | Definition of steel products |
| EN 10088-2:2014 | Stainless steels - Part 2: Technical delivery conditions for sheet/plate and strip of corrosion resisting steels for general purposes |
| EN 10258 : 1997 | COLD-ROLLED STAINLESS STEEL AND NARROW STRIP AND CUT LENGTHS - TOLERANCES AND DIMENSIONS AND SHAPE |