DIN EN 60071-2 : 1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
INSULATION CO-ORDINATION - PART 2: APPLICATION GUIDE
12-01-2013
03-07-2021
Vorwort
Anerkennungsnotiz
1 Allgemeines
1.1 Anwendungsbereich
1.2 Normative Verweisungen
1.3 Verwendete Formelzeichen
2 Repräsentative Spannungsbeanspruchungen im Betrieb
2.1 Ursache und Klassifizierung von
Spannungsbeanspruchungen
2.2 Eigenschaften von Überspannungsschutzgerdten
2.3 Repräsentative Spannungen und Überspannungen
3 Koordinationsstehspannung
3.1 Eigenschaften der Isolationsfestigkeit
3.2 Auswahlkriterium
3.3 Verfahren der Isolationskoordination
4 Erforderliche Stehspannung
4.1 Allgemeines
4.2 Atmosphärisch bedingte Korrektur
4.3 Sicherheitsfaktoren
5 Bemessungsspannung und Prüfverfahren
5.1 Allgemeines
5.2 Prüf-Umrechnungsfaktoren
5.3 Bestimmung des Stehvermögens der Isolation durch
Typprüfungen
6 Spezielle Betrachtungen für Freileitungen
6.1 Allgemeines
6.2 Isolationskoordination für Betriebsspannungen und
zeitweilige Überspannungen
6.3 Isolationskoordination für langsam ansteigende
Überspannungen
6.4 Isolationskoordination für Blitzüberspannungen
7 Besondere Überlegungen zu Umspannstationen
7.1 Allgemeines
7.2 Isolationskoordination für Überspannungen
Anhänge
Anhang A (normativ): Luftstrecken zur Sicherstellung
einer festgelegten Stehstossspannung in Anlagen
Anhang B (informativ) Bestimmung zeitweiliger
Überspannungen infolge von Erdfehlern
Anhang C (informativ): Weibull-Wahrscheinlichkeitsverteilungen
Anhang D (informativ): Bestimmung der repräsentativen,
langsam ansteigenden Überspannungen für das
Einschalten und Wiedereinschalten von Leitungen
Anhang E (informativ): Übertragung von Überspannungen in
Transformatoren
Anhang F (informativ): Blitzüberspannungen
Anhang G (informativ): Berechnung der
Durchschlagfestigkeit von Luftstrecken aus
Versuchsergebnissen
Anhang H (informativ): Beispiele zum Verfahren der
Isolationskoordination
Anhang J (informativ): Literaturhinweise
Anhang ZA (normativ): Normative Verweisungen auf
Internationale Publikationen mit ihren
entsprechenden europäischen Publikationen
Consists of an application guide concerned with selecting insulation levels of equipment or installations for three-phase electrical systems. Gives guidelines for determining the rated withstand voltages for ranges 1 and II of IEC 71-1 and justifies association of these values with standardized highest voltages for equipment.
| DevelopmentNote |
Supersedes DIN 57111-3. (06/2004) DRAFT 2017 issued in November 2017. (11/2017)
|
| DocumentType |
Standard
|
| PublisherName |
Verband Deutscher Elektrotechniker
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| BS EN 60071-2:1997 | Identical |
| I.S. EN 60071-2:1999 | Identical |
| NF EN 60071-2 : 1997 | Identical |
| IEC 60071-2:1996 | Identical |
| NBN EN 60071-2 : 1998 | Identical |
| EN 60071-2:1997 | Identical |
| VDE 0111-2 : 1997 | Corresponds |
| UNE-EN 60071-2:1999 | Identical |
| VDE 0111-2 : 1997 | Identical |
| VDE 0674-1:2001-12 | TESTS ON INDOOR AND OUTDOOR POST INSULATORS OF CERAMIC MATERIAL OR GLASS FOR SYSTEMS WITH NOMINAL VOLTAGES GREATER THAN 1 KV |
| DIN EN 50186-1:1999-01 | LIVE-LINE WASHING SYSTEMS FOR POWER INSTALLATIONS WITH RATED VOLTAGES ABOVE 1 KV - PART 1: GENERAL REQUIREMENTS |
| DIN IEC/TR 62543 : 2018 | HIGH-VOLTAGE DIRECT CURRENT (HVDC) POWER TRANSMISSION USING VOLTAGE SOURCED CONVERTERS (VSC) (IEC/TR 62543:2011 + A1:2013 + A2:2017) |
| DIN EN 60168:2001-12 | TESTS ON INDOOR AND OUTDOOR POST INSULATORS OF CERAMIC MATERIAL OR GLASS FOR SYSTEMS WITH NOMINAL VOLTAGES GREATER THAN 1 KV |
| VDE 0101 : 2000 | POWER INSTALLATIONS EXCEEDING 1 KV |
| VDE 0553-543 : 2018 | HIGH-VOLTAGE DIRECT CURRENT (HVDC) POWER TRANSMISSION USING VOLTAGE SOURCED CONVERTERS (VSC) (IEC/TR 62543:2011 + A1:2013 + A2:2017) |
| VDE 0143-1:1999-01 | LIVE-LINE WASHING SYSTEMS FOR POWER INSTALLATIONS WITH RATED VOLTAGES ABOVE 1 KV - PART 1: GENERAL REQUIREMENTS |
| VDE 0441-5 : 2002 | COMPOSITE STRING INSULATOR UNITS FOR OVERHEAD LINES WITH A NOMINAL VOLTAGE GREATER THAN 1 KV - DIMENSIONAL AND ELECTRICAL CHARACTERISTICS |
| VDE 0670-105 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - GUIDE TO THE SELECTION OF CIRCUIT-BREAKERS FOR SERVICE |
| VDE 0675-1 : 2000 COR 1 2000 | SURGE ARRESTERS - PART 1: NON-LINEAR RESISTOR TYPE GAPPED SURGE ARRESTERS FOR A.C. SYSTEMS |
| DIN EN 60099-4 : 2015 | SURGE ARRESTERS - PART 4: METAL-OXIDE SURGE ARRESTERS WITHOUT GAPS FOR A.C. SYSTEMS (IEC 60099-4:2014) |
| DIN VDE 0670-101 : 1992 | A.C. SWITCH GEAR AND CONTROL GEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - GENERAL AND DEFINITIONS |
| VDE 0670-106 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - INFORMATION TO BE GIVEN WITH ENQUIRIES, TENDERS AND ORDERS AND RULES FOR TRANSPORT, STORAGE, ERECTION AND MAINTENANCE |
| VDE 0111-1 : 2010 | INSULATION CO-ORDINATION - PART 1: DEFINITIONS, PRINCIPLES AND RULES |
| DIN IEC 60721-2-3:1990-06 | ELECTRICAL ENGINEERING; CLASSIFICATION OF ENVIRONMENTAL CONDITIONS; ENVIRONMENTAL CONDITIONS APPEARING IN NATURE, AIR PRESSURE |
| VDE 0675-4 : 2015 | SURGE ARRESTERS - PART 4: METAL-OXIDE SURGE ARRESTERS WITHOUT GAPS FOR A.C. SYSTEMS (IEC 60099-4:2014) |
| VDE 0670-102 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - RATING |
| IEC 60099-4:2014 | Surge arresters - Part 4: Metal-oxide surge arresters without gaps for a.c. systems |
| VDE 0670-104 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - TYPE TESTS AND ROUTINE TESTS |
| VDE 0670-101 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - GENERAL AND DEFINITIONS |
| DIN EN 60507:2014-09 | ARTIFICIAL POLLUTION TESTS ON HIGH-VOLTAGE CERAMIC AND GLASS INSULATORS TO BE USED ON A.C. SYSTEMS |
| DIN VDE 0670-106 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV; HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - INFORMATION TO BE GIVEN WITH ENQUIRIES, TENDERS AND ORDERS AND RULES FOR TRANSPORT, STORAGE, ERECTION AND MAINTENANCE |
| IEC 60056:1987 | High-voltage alternating-current circuit-breakers |
| IEC 60505:2011 | Evaluation and qualification of electrical insulation systems |
| VDE 0448-1:2014-09 | Artificial pollution tests on high-voltage ceramic and glass insulators to be used on a.c. systems (IEC 60507:2013); |
| IEC 60099-1:1991+AMD1:1999 CSV | Surge arresters - Part 1: Non-linear resistor type gapped surge arresters for a.c. systems |
| DIN EN 60099-1 : 2000 COR 1 2000 | SURGE ARRESTERS - PART 1: NON-LINEAR RESISTOR TYPE GAPPED SURGE ARRESTERS FOR A.C. SYSTEMS |
| IEC 60099-5:2013 | Surge arresters - Part 5: Selection and application recommendations |
| VDE 0432-1:2011-10 | HIGH-VOLTAGE TEST TECHNIQUES - PART 1: GENERAL DEFINITIONS AND TEST REQUIREMENTS |
| DIN EN 60071-1 : 2010 | INSULATION CO-ORDINATION - PART 1: DEFINITIONS, PRINCIPLES AND RULES |
| DIN VDE 0670-105 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - GUIDE TO THE SELECTION OF CIRCUIT-BREAKERS FOR SERVICE |
| DIN VDE 0670-103 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - DESIGN AND CONSTRUCTION |
| IEC 60060-1:2010 | High-voltage test techniques - Part 1: General definitions and test requirements |
| IEC 60507:2013 | Artificial pollution tests on high-voltage ceramic and glass insulators to be used on a.c. systems |
| DIN VDE 0670-102 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - RATING |
| IEC 60071-1:2006+AMD1:2010 CSV | Insulation co-ordination - Part 1: Definitions, principles and rules |
| DIN IEC 60060-1 : 1994 | HIGH VOLTAGE TEST TECHNIQUES - GENERAL SPECIFICATIONS AND TEST REQUIREMENTS |
| DIN VDE 0670-104 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - TYPE TESTS AND ROUTINE TESTS |
| VDE 0670-103 : 1992 | A.C. SWITCHGEAR AND CONTROLGEAR FOR VOLTAGES ABOVE 1 KV - HIGH-VOLTAGE A.C. CIRCUIT-BREAKERS - DESIGN AND CONSTRUCTION |
| IEC 60721-2-3:2013 | Classification of environmental conditions - Part 2-3: Environmental conditions appearing in nature - Air pressure |