DIN EN ISO 6892-1:2017-02

National foreword
National Annex NA (informative) - Indices for the percentage
                  elongation after fracture
National Annex NB (informative) - Comparison of international
                  symbols used in tensile testing
National Annex NC (informative) - Bibliography
European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Principle
6 Test pieces
7 Determination of original cross-sectional area
8 Original gauge length and extensometer gauge length
9 Accuracy of testing apparatus
10 Conditions of testing
11 Determination of the upper yield strength
12 Determination of the lower yield strength
13 Determination of proof strength, plastic extension
14 Determination of proof strength, total extension
15 Method of verification of permanent set strength
16 Determination of the percentage yield point extension
17 Determination of the percentage plastic extension
   at maximum force
18 Determination of the percentage total extension at
   maximum force
19 Determination of the percentage total extension at fracture
20 Determination of percentage elongation after fracture
21 Determination of percentage reduction of area
22 Test report
23 Measurement uncertainty
Annex A (informative) - Recommendations concerning the use of
        computer-controlled tensile testing machines
Annex B (normative) - Types of test pieces to be used for thin
        products - sheets, strips, and flats between 0,1 mm
        and 3 mm thick
Annex C (normative) - Types of test pieces to be used for
        wire, bars, and sections with a diameter or thickness
        of less than 4 mm
Annex D (normative) - Types of test pieces to be used for
        sheets and flats of thickness equal to or greater
        than 3 mm and wire, bars, and sections of diameter
        or thickness equal to or greater than 4 mm
Annex E (normative) - Types of test pieces to be used for tubes
Annex F (informative) - Estimation of the crosshead separation
        rate in consideration of the stiffness (or compliance)
        of the testing equipment
Annex G (normative) - Determination of the modulus of elasticity
        of metallic materials using a uniaxial tensile test
Annex H (informative) - Measuring the percentage elongation after
        fracture if the specified value is less than 5%
Annex I (informative) - Measurement of percentage elongation after
        fracture based on subdivision of the original gauge length
Annex J (informative) - Determination of the percentage plastic
        elongation without necking, A[wn], for long products
        such as bars, wire, and rods
Annex K (informative) - Estimation of the uncertainty of measurement
Annex L (informative) - Precision of tensile testing - Results from
        interlaboratory programmes
Bibliography

Defines the method for tensile testing of metallic materials and defines the mechanical properties which can be determined at room temperature.