DIN VDE 0721-911 : 1988
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
INDUSTRIAL ELECTROHEAT INSTALLATIONS - GENERAL SAFETY REGULATIONS
12-01-2013
01-08-1995
1 Anwendungsbereich
2 Zweck
3 Begriffe
4 Einteilung der Elektrowärmeeinrichtungen nach
Spannungsbereichen
5 Einteilung der Elektrowärmeeinrichtungen nach
Frequenzbereichen
6 Allgemeine Anforderungen
7 Verbot der Einbeziehung leitfähiger Teile in den
Stromkreis
8 Kennzeichnungen, Aufschriften und Schaltpläne
9 Schutz gegen Überstrom
10 Trennung vom Netz und Schalten
11 Anschluss an das Netz und innere Verbindungen
12 Schutz gegen elektrischen Schlag
13 Schutz gegen thermische Einflüsse
14 Brand- und Explosionsgefahr
15 Prüfung, Inbetriebnahme, Betrieb und Instandhaltung
von Elektrowärmeanlagen
| DocumentType |
Standard
|
| PublisherName |
German Institute for Standardisation (Deutsches Institut für Normung)
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| VDE 0721-911 : 1995 | Identical |
| VDE 0721-411 : 1995 | SAFETY IN ELECTROHEAT INSTALLATIONS - PART 2: PARTICULAR REQUIREMENTS FOR RESISTANCE HEATING EQUIPMENT |
| DIN 40100-3:1985-07 | GRAPHICAL SYMBOLS FOR USE ON EQUIPMENT IN THE ELECTROTECHNICAL FIELD; CURRENT, VOLTAGE, FREQUENCY, CONDUCTORS, METHODS OF EARTHING |
| DIN VDE 0470-1 : 1992 | |
| DIN VDE 0100-300 : 1996 | ERECTION OF POWER INSTALLATIONS WITH NOMINAL VOLTAGES UP TO 1000 V - PART 3: ASSESSMENT OF GENERAL CHARACTERISTICS OF INSTALLATIONS |
| DIN VDE 0100 : 1973 | ERECTION OF POWER INSTALLATIONS WITH RATED VOLTAGES BELOW 1000 V |
| DIN VDE 0100-540 : 2012-06 | LOW-VOLTAGE ELECTRICAL INSTALLATIONS - PART 5-54: SELECTION AND ERECTION OF ELECTRICAL EQUIPMENT - EARTHING ARRANGEMENTS AND PROTECTIVE CONDUCTORS (IEC 60364-5-54:2011) |
| DIN VDE 0141 : 2000 | EARTHING SYSTEM FOR SPECIAL POWER INSTALLATIONS WITH NOMINAL VOLTAGES ABOVE 1 KV |
| DIN VDE 0165 : 1991 | ERRICHTEN ELEKTRISCHER ANLAGEN IN EXPLOSIONSGEFAEHRDETEN BEREICHEN |
| DIN VDE 0100-430:2010-10 | LOW-VOLTAGE ELECTRICAL INSTALLATIONS - PART 4-43: PROTECTION FOR SAFETY - PROTECTION AGAINST OVERCURRENT |
| DIN VDE 0101 : 2000 | POWER INSTALLATIONS EXCEEDING 1 KV |
| IEC 60050-841:2004 | International Electrotechnical Vocabulary (IEV) - Part 841: Industrial electroheat |
| DIN 40705:1980-02 | IDENTIFICATION OF INSULATED AND BARE CONDUCTORS BY COLOURS |
| DIN VDE 0100-200 : 2006-06 | LOW-VOLTAGE INSTALLATIONS - PART 200: DEFINITIONS |
| IEC 60050-826:2004 | International Electrotechnical Vocabulary (IEV) - Part 826: Electrical installations |
| VDE 0100-46 : LATEST | ERECTION OF POWER INSTALLATIONS WITH RATED VOLTAGES BELOW 1000V - CHAPTER 46: ISOLATION AND SWITCHING |
| DIN VDE 0100 G : 1976 | REGULATIONS FOR THE SETTING-UP OF POWER PLANTS WITH RATED VOLTAGES UP TO 1000 V |
| DIN V 8418:1988-02 | USER'S INFORMATION; REFERENCES FOR THE PRESENTATION |
| DIN VDE 0105-1 : 1983 | OPERATION OF POWER INSTALLATIONS; GENERAL REQUIREMENTS |
| VDE 0100-537 : 1999 | ELECTRICAL INSTALLATIONS OF BUILDINGS - PART 5: SELECTION AND ERECTION OF ELECTRICAL EQUIPMENT; CHAPTER 53: SWITCH GEAR AND CONTROL GEAR; SECTION 537: DEVICES FOR ISOLATION AND SWITCHING |